SOURCE: Need fuse panel diagram for 2002 BMW 325xi
This is what I could find. It doesn't have a steering whee radiol control fuse but has 2 fuses for the radio. It seems to be the same panel across the board for BMW's. 4x4's, diesels, gas, 6 and 8 cylinders, etc. Hope it helps.
SOURCE: changing headlamps on 2003 bmw 325xi
I am assuming that you have a burned out head light bulb.
1) Open hood.
2) Working in back of headlight assembly, grasp rear of bulb socket (harness connector) and turn counterclockwise 90 degrees. Pull bulb out of headlight assembly.
3) Disconnect harness connector from bulb (gently pry, it's plastic)
4) Installation is reverse of removal. (Do not touch halogen bulb with bare skin-oils from hand will cause bulb to burn out.) Align tabs on bulb base to cutouts on rear of lens assembly. (Note bottom tab is wider than other two) Secure bulb by rotating clockwise 90 degrees.
Low beam bulb H9006
High beam bulb H9005
SOURCE: BMW 2001 325xi Power Steering noise / vibration
no filter, sounds like the steering rack is worn out and need to be rebuilt.
SOURCE: 2003 BMW 325xi won't start, dashboard and radio go on.
My 2003 325xi died on the highway a few weeks ago, and I thought it was the battery. It turned out to be the alternator, which was an expensive problem to repair. If your battery is new, it could be the alternator, or a problem with the electrical system. I find the BMWs to be too complicated electrically, which often leads to problems! I'd check your alternator...
SOURCE: i need the fuse box diagram for a 2004 325xi
2004 BMW 325XI AWD 2.5L EFI DOHC 6cyl
Fusible links are often identified by the color coding of the
insulation. Refer to the accompanying illustration for wire link size
and color.
Fig. Common fusible link color coding
Circuit Breakers - Resetting & Replacement
Circuit
breakers are located inside the fuse panel. They are automatically
reset when the problem corrects itself, is repaired, or the circuit
cools down to allow operation again.
Fuses Replacement
Use the
provided plastic fuse puller located in the fuse panel to remove fuses.
The upper lid of the fuse panel has a diagram of the fuse locations and
amperage ratings for each circuit. The fuse is removed by simply
pulling upward on the fuse with the removal tool.
The fuses are easily checked by visual inspection. With the ignition switch
OFF
pull the fuse out of the holder. Check the fuse filament. It should be
continuous and not broken. If the filament is broken, replace the fuse
with one of the same amperage rating.
The fuse and relay box on the E30 and E36 models is
located in the engine compartment. The E36 models also has relay boxes
located under the left side of the dashboard.
The diagram is in section 610 of the Bentley Manual. Some have downloaded it through a link provided here: http://www.bimmerwerkz.com/forum/3-s...4-a-50762.html
Good luck.
149 views
Usually answered in minutes!
×