May be you should to reset the ecu
so you can do it in a garage or you can do it by yourself
if you want to solve it by yourself you need a tool
and you can click here: ecu chip tuning tools
SOURCE: diagram for serpentine belt for 2002 BMW 525i
An image of a serpentine belt, hope this will help you,
Eitan.
SOURCE: How to set-up handsfree system on 2002 bmw 525i?
turn on bluetooth to your vehicle...open your phone to bluetooth you should see a menue that says pair devece or look for devices to pair with click on that and let it searchh that should fix the prob...
SOURCE: ABS and anti skid tracking control lights stay on in my BMW 523i
Unfortunately there are several possibilities that are common to causing the light to come on. I would suggest taking the car in to a dealer and having them read out the fault memory. Such possibilities are a failed speed sensor, a binding DSC/ACS actuator cable, or faulty DCS/ASC control unit. If you know how, you can disconnect the speed sensors, and check for voltage output across the the terminals inside the connector going to the speed sensor while rotating the wheel. A dealer should charge you about an 1hour fee to check out your system. Due to the cost of parts involved, I would recommend having it checked before just guessing.
SOURCE: bmw 316 ABS light stays on
Your ABS systems use a combination of electronic and hydraulic systems to modulate the brakes individually to prevent them from locking up. Antilock systems consist of wheel speed sensors, a hydraulic control unit (HCU), and an electronic control unit (ECU). Because of how complex the system is your computer does a self-test. If the check is successful, the ANTILOCK and BRAKE lights will go out within a few seconds. If one or more of the component of the ABS system fails to pass one or both lights will remain lit, the system will shut down and set a code. The code itself does not tell exactly what component is defective - it only indicates where to look, or what parameter is out of normal range. You or a technician will have to perform further testing to pinpoint cause and the proper repair. Even if you reset the light, if the underlying problem is not addressed it will come back on.
Please let me know if this information is helpful. Positive feedback is appreciated. Thank You!
SOURCE: Check Engine light on 1998 BMW Z3 roadster
yes the light is because of the gas cap being gone (sets code in evaporative emissions system), replace the gas cap, disconnect the battery for five minutes and that will turn of/reset the light, make sure u have the radio code before u do this, if u don't u will have no radio after the battery is disconnected..
108 views
Usually answered in minutes!
×