2007 gmc sierra won't start. Noticed on Sunday (today is Wed) issue with cruise control and seat heater.

SOURCE: 2005 GMC Sierra Overheating

If your sure there is no trapped air in system after refill and air bleed off, is fan clutch pulling good air thru radiator? Even if it is, the heater should have coolant as hot as what temp gage is showing! Try backwards flushing heater core (dex cool is notorious for plugging these up). There is a TSB for cracked cylinder heads from GM for unexplained coolant loss.Remove drivers side valve cover, and look at center three head bolts for coolant around them, if coolant has been getting in thru this suspect area, there will be a milky/pudding like goo under valve cover and on head. GM had a company called Castec cast these and the areas near the head bolts were found to be too porous (NO recall YET!) Ya, you guessed it, replace heads! Unfortunately, if its gotten hot to many times, it has probably hurt the heads/gaskets. Hope this helps. PS: The castec logo is under the rearmost pair of rocker arms,may have to remove them to see.

SOURCE: cruise control wont work

normally the brake switch is the issue with these trucks. it is located under the dash where the brake pedal meets the linkage to the brake booster.

SOURCE: 2005 gmc sierra 2500hd heated seat turns off

you have a couple of problems first of all your drivers sd=ide heated heat pad is probably faulty, for your heating problem you may have to get the hvac doors recalibrated.

SOURCE: 2004 gmc 1500 sierra heater control stuck on

Defrost is the default position. Is the control a autyomatic temperture control unit? ( you set the temp and select automatic) if it is the system is completely electronic. You push the buttons and the control still says defrost or can you select something else and the control shows it but it just keeps coming out the defrost? If the control changes and the air comes out the defrost anyway and the cheack engine light isn't on, then the problem can be blown fuses or an air door actoater not working. Does the dash emit a clicking sound? if it does with the covers off the bottom of the dash reach around touching the different pieces till you touch the idem that is clicking. this is an acutor motor, or blend door motor. they have gears in them that wear out and break the motors aren't repairable and you just replace the ofending motor. the door that is moves can be stuck. and may have to be freed up with blaster, WD40, or other rust buster till it moves easy. maybe after getting the door to move smoothly you can get the old motor to move the door wiithout having to install a new one.

SOURCE: 1990 GMC Sierra 1500 pickup. Windshield wipers, Cruise Control

May want to look at replacing the wiper circuit board.It is located on the firewall adjacent to the wiper motor and has a some what square black cover with 3 torx screws and wireing harness pluged into the side.We had a truck that every time you washed it the wipers would stay on until it dryed out.You can try removing it and spaying it down with contact cleaner just watch the brease on the two contact tips.Well hope this helps.