SOURCE: 1994 Dodge Caravan rear brakes won't wear out.
Yes, this is very normal. You'll replace the front 3 times before you'll have to replace the rears. The reason for this is because 80% of your braking is in the front. There is nothing wrong with your brake system.
SOURCE: air conditioner blower motor resister on dodge grand caravan
in my 2004 grand caravan it's behind the glove box and left of the blower motor. disconnect the wires first then remove the 2 screws to pull out the resistor unit. First make sure you have removed the negative of your batterie. I had the same pm that prevented the blower motor to operate in any speed. I hope this will help
SOURCE: Dodge Caravan radio won't work
you need to check fuses on the drivers side dash panel. look for the iod fuse may be 2 unplugg the iod fuse then plug it back in
SOURCE: overheating 97 dodge caravan sport
i had the same problem, i dont remember the name of the piece but its mounted right in between the driver side headlight and the radiator. its a relay that turns the fans on when the car gets hot. its mounted on the body of the car. there should be wires leading from the radiator to the piece im talking about.... good luck I also paid about 35 dollars for the piece
SOURCE: Need serpentine belt routing diagram for 1994 Dodge grand caravan
3.3L?
Looking at the engine from front (right side of the Van): Stating at the Top, Going Left to Right and Clockwise:
Over the Alternator
To under the Idle Pulley,
To Over the AC Compressor.
To the Left Side of the Water Pump.
To the Right side and Under the Crankshaft Pulley
To the Right side and Over and Down the Tensioner
To Under the Power Steering Pump
And Back up-to the Left side of the Alternator.
Advise when puting it on:
Put the Belt around everything else accept for the Alternator. After it is around all the rest of the Pulleys - Pull the belt up - tight from the Power steering Pump and the Idle Pulley to form a loop, holding the Belt close to the Altenator Pulley.
Using the 15mm wrench or belt tensioner bar - rotate the Tensioner Pulley towards the front of the Van and then place the belt over the Alternator.
Let me know if this helped or if you have additional information or questions. Feel free to contact me at FixYa.com!
45 views
Usually answered in minutes!
×