I need to know where the transmission mount and motor =mounts are located so i can replace them
SOURCE: replacement of the serpentine belt on 1997 buick lesaber how
Yes, I have a 97 buick and the motor mount does have to be removed. See information below that I retireved from Autozone.com:
REMOVAL & INSTALLATION
See Figures 7 through 13
Fig. 7: Many vehicles have an accessory drive belt routing label affixed to the radiator shroud
SOURCE: Need to replace tail light bulb on 1996 Buick Century
Inside the trunk, under the carpet behind the tail lights will be a whole bunch of small plastic nuts, running from one side of the car to the other. Take all of these plastic nuts off, and the whole tail light assembly will come off in one large piece. Find the bulb you need to replace, and reassemble
SOURCE: Need to know roughly how long it would take to
Depends on your level of experience, quality of your tools and whether or not you have any frozen head bolts. The valve assembly and head come off as one unit on those. To clear the wires, emmision controls ect off of the top of the valve cover 30 minutes. remove valve cover 5 minutes (too scrape off excess gasket material. to remove exhaust manifold from side of head, (assuming no broken/stuck/stripped bolts 15 minutes with good hydraulic tools. To remove head (assuming all goes well and hydraulic tools, 15 minutes. To reassemble, double all times as surfaces need to be prepped and gaskets applied and proper torque on all bolts. It's an afternoon job if you ahve everything you need and nothing goes wrong. Typically add at least two or three hours of drilling and cursing to a head gasket replacement. and a trip for new drill bits and a tap (not beer) for the new hole you drilled.
SOURCE: motor mounts and pulley tensioner
I was wondering how do you take off the front transmission mount on a 1997 buick park avenue
546 views
Usually answered in minutes!
×