Both back windows stopped working at the time time. What should I look for?
SOURCE: Speedometer stopped working
pretty common for the cable to break,if you get under the vehicle disconnect it from the gearbox and tug the inner cable it should not come out...if it does you know the problem....if it doesnt put a battery drill on the cable....dont start the engine but leave the ignition on a spin the drill if your speedo dont work then you need a new speedo head.....but that is very uncommon!!!!!!!!!!!!!!!!
SOURCE: radio unlock code for 1998 land rover discovery
Give the dealership your VIN# and they will in turn provide you with an 'unlock' code. Input the code and you should have radio. If not, you will need to remove the radio and give the dealer the chassis # found on the case.
SOURCE: what is code p1496 check engine light error mean
OBD code P1496 - low sensor output voltage (4v or less for 4 seconds)
SOURCE: how can i put the radio code to my land rover 1998
Hi there,
I think its fairly standard across all Land Rovers. First of all you need a code. This was supplied on a credit card sized piece of card with the original vehicle. I'l assume its not to hand... Typically, you can source the code (which is specific to your serial number / radio) from a supplier such as this on eBay: http://cgi.ebay.com/Landrover-Radio-Code-Decode-Service-4775-Navigation-/380181370976?cmd=ViewItem&pt=UK_Audio_TV_Electronics_In_Car_Entertainment_GPS_In_Car_Audio_Players_PP&hash=item5884935860 Code in hand, you are ready to enter it and unlock the radio.
You only actually need numbered button <1> and the two seek buttons that look like <| and >| .
-------------
When you turn the radio on, you should see it request <CODE>
Press preset button <1>. This should identify character 1 of the code.
Use one of the two tuning buttons (Seek up , or seek down - the ones with arrows going into lines) to move to the right number (0-9).
Press preset button <1> again to lock digit 1 and move onto code digit 2.
Repeat twiddling the upseek and downseek. Press button 1 etc .... until all four codes have been entered.
When you press <1> for the final time, if the code is correct, you'll get a two tone beep to confirm and the radio is unlocked.
If incorrect, you are progressively locked out (in doubling time periods).
Hope this helps.
SOURCE: how to replace a fuel pump for a land rover
first disconect fuel lines then drop the tank down on the ground fuel pump is on the top pull fuel pump out drop new one in,need to change fuel pump relay when replaceing fuel pump relay is under hood in the fuse box.
38 views
Usually answered in minutes!
×