I have jaguar xjs 1988 model i need to know the timing marks on the timing chain

SOURCE: timing chain mark diagram for a 94 grand am????

Haynes lists the entire procedure for setting the position of the cams etc. Positioning of these is critical...If off by even a slight amount the valves WILL strike the pistons and destroy the engine. DO NOT use any parts made by SA Gear...They have no quality control and will deny any claim made against them. Make sure that the chain guides are in good condition and that the chain tensioner is operating properly.

SOURCE: timing chain replacement

http://jeg.serverhouse.com/Jag_docs/Timingchain.pdf

Here it will show you step by step on how to do the job.

[email protected]

SOURCE: Need timing marks for 2002 ford explorer 4.0

The Info I Have Is Extensive and Has Illistrations, I Need to Emali it to You As it is Very Large, This Is A Small Example Im @[email protected]

Special Tool(s)

1. With the vehicle in neutral, position it on a hoist.
2. Remove the intake manifold.
3. Remove the fuel supply manifold.
4. Remove the accessory drive belt.
5. Remove the thermostat housing.
6. Remove the roller followers.
7. NOTE: You must retime the LH and RH camshafts when either camshaft is disturbed. Turn the crankshaft clockwise to position the number one cylinder at top dead center (TDC).
8. NOTE: Late build pulley shown, early build pulley similar. NOTE: The special tool must be installed on the damper and should contact the engine block to position the engine at TDC.

SOURCE: Need timing marks for 2002 ford explorer 4.0

There are no marks on this one. There is a special tool set to align camshafts ($900). The best you can do is to bring #1 cyl to TDC compression with both cam(valve) covers off. #5 cyl should have lobes at equal opening, exhaust just closing and intake just opening.. #1 cyl cam lobes should each be diametrically opposed to the positions of #5. If cams need to be moved, there is no registration of gear onto cam. Just loosen bolt holding gear and move cam. Retighten bolt. Roll thru 2 crank revolutions and check cam timing again.Simple.

SOURCE: what are the timing mark positions for 2000 jaguar

there are no marks , there are special tools for adjusting the timing properly