The windscreen wipers work i only get a weak flow of water from the drivers side and none through the other one
There is a very good possibility that the nozzeles are plugged with "debris". Try using compressed air to force the "debris" out of the nozzles. This is best done by removing the lines going to the nozzles and and blowing the compressed air through the nozzles from the directon in wich they are intended to spray. A toothpick or metal pick may work as well to loosen the "debris" depending on the size of the nozzle.
SOURCE: windscreen washer won't work
the tube goes along side the apron and goes into the bottom of the washer reservoir which is behind the headlighplease rate my response thank you very much
SOURCE: Windscreen Washer
If it is the same as some other Chevrolets they have 2 pumps attached to the side of the washer bottle. 1 for rear and 1 for front windscreen
SOURCE: wont stay tight wiper arm
The wiper arm has teeth on it that hold it the spindle, those teeth wear out and let the wiper arm flop all over. You need a new wiper arm, if it is under warranty I'd take it in, if not changing awiper arm is easy. I've seen this on several kias, and also on other foriegn cars. It is just a bad design in my opinion.
SOURCE: peugeot 1007 windscreen washer water jets
Hi
It is usually the fuse. This blows very easily.(eg Ifyou operaten the washers when the fluid is frozen or partially frozen)
Look in your handbook. And in the fuse box in the engine compartment
Regards
Vince
SOURCE: Windscreen wiper snapped-Peugeot 206 Verve 52 plate
this just happened to us, the drivers side stopped working after getting tangled up with the passenger side...it was just a case of tightening up the 13mm nuts on the wiper arm.
266 views
Usually answered in minutes!
×