I purchased a used keyless entry module and key fobs that are already programmed for that module from eBay, but I don't know where the keyless entry module is located on my car to change it or add it if it is not already installed. I got the car used and it did not come with any key fob. I am trying to either make the keyless entry work, or add it if it does not currently exist. I am assuming that the plug for the module would still be there even if the module is not installed.
SOURCE: Keyless Entry for 2003 Grand Am
This is a Dealer Option and they all Charge Different Prices. I have heard of Prices from 50.00 to 175.00 depending on what Options are on the Car.
SOURCE: need to program fob l22733524
GM FOBS cannot be reprogrammed at home...Dealer ($90-125) or go to a local car stereo shop and get their new keyless entry installed ($89)
Good Luck
SOURCE: Do key fobs loose memory (06 Pontiac Grand Prix)
do you have the owner manuals .... it tells you how to program them for that car
SOURCE: How do I reset a Key Fob for my 2006 Grand Prix
No Tools Required
In the event that a transmitter is lost,
program the old and the new transmitters into the memory of the remote
control door lock receiver. Up to 4 transmitters may be programmed.
Important
Once the keyless entry receiver enters the
programming/diagnostic mode, the programming of the first transmitter
erases all previous transmitter programming information. You must then
program all of the transmitters.
Program only 1 vehicle remote control door lock receiver at a
time. If you program multiple receivers simultaneously, the same
transmitter could possibly be programmed to more than 1 remote control
door lock receiver.
Perform the following steps:
Sit in the vehicle driver's seat. (actually it’s much ezr from the front pass seat)
Remove the ignition key from the ignition lock cylinder.
Close all of the vehicle's doors.
Remove the MALL PGM fuse from the fuse panel. Refer to Electronic Diagnosis in Body and Chassis.
Turn the ignition lock cylinder to the ACC position.
Turn the ignition lock cylinder OFF, then back to ACC within 1 second.
Open
and then close any vehicle door. You will hear a chime when the remote
control door lock receiver enters the programming/diagnostic mode. If
you do not hear a chime, start again at step 1.
Important
After 7 seconds, you may hear a chime confirming
successful synchronization. After approximately 14 seconds, you will
hear a chime confirming successful programming.
Press and hold the transmitter LOCK and UNLOCK buttons simultaneously for 14 seconds.
Repeat step 8 in order to program each additional transmitter.
Remove the ignition key from the ignition lock cylinder.
Install the MALL PGM fuse back into the fuse panel. Refer to Electrical Diagnosis in Body and Chassis.
Validate that all the transmitters that were programmed operate properly. Refer to Keyless Entry System Operation
1,453 views
Usually answered in minutes!
×