No u
SOURCE: Ford F250 Superduty Diesel Will not start
the crank position sensor on the front of the engine has been the most problematic parts. that is where i would start
SOURCE: 2000 Ford Expedition wont start
On the engine there is a tube that supplies fuel to the fuel injectors, on that tube there is a valve, like a metal tire valve, this is the fuel pressure test port, you will need a special guage to check the pressure that screws onto that valve, Kragen and other parts stores sell this test kit, it is very inexpensive, about $20.00, but cheaper than having a shop do it for you, if you do the test and you have no pressure while cranking the engine then your fuel pump is bad, the pump is in the gas tank, a big job and dangerous due to chance of fire if you are not cautious.
SOURCE: 1966 mustang engine cranks but wont start
Guide to starting a dead horse!
1- Spray a little starter fluid down the carbuerator. If it tries to fire, your timing and ignition is probably OK. This could indicate a carb or fuel pump problem.
2- If it doesn't fire, check out the points, condenser, coil, distributor cap and rotor. Look for condensation inside the cap. Check that the high tension wire from the coil to distributor is in good shape and not touching the engine or any brackets,etc.
3- Verify that your timing is correct. You may have a timing train problem (Worn or broken).
4- The distributor may have come loose and changed positions. Check for proper timing.
5- It may be a compression problem. If it has set long enough for the oil that coats the cylinder walls to drain down, you won't have enough compression to allow firing. Check your compression and if this seems to be the case, remove the spark plugs and squirt a little Marvel Mystery oil, or similar light weight oil into each cylinder. When it starts, it will smoke for a few minutes, but that will go away.
Hope this helps and if not, get back to me.
Have a super day!
Ron
SOURCE: i have a 1992 ford f250 7.3l powerstroke it wont start up
You need to check the glow plug system. Check for power from the glow plug relay.
46 views
Usually answered in minutes!
×