If i install new cd player and disconnect neg terminal on battery will this permanently engage killswitch?

Question 1

0helpful

1answer

How do i reset the cd player/exchanger of my 2000 dodge neon es. The lights continuously blink since the battery was disconnected to clean the heater core.

pull your neg . cable off battery then turn your key to on position ...leave on for 15 to 30 seconds .then turn to off position ..reconnect neg cable

Jan 05, 2015 • 2000 Dodge Neon

0helpful

1answer

03 chevy silverado aftermarket cd player

Maybe the sudden shock when connecting cable blew out the in-line fuse

Jun 16, 2013 • Cars & Trucks

0helpful

1answer

Alternator replacement.

I have done this on my 1993 skylark

1. DISCONNECT NEGITIVE BATTERY TERMINAL!!!!!

2. using a 1/2in drive ratchet (or 3/8 drive on some models) koosen the belt tensioner and remove ther serpentine belt from the alternator pulley

3. remove 2 alternator retaining bolts on either side of pulley

4. disconnect pos. and neg. battery connectors

5. remove alternator

installation is the reverse of removal

Aug 21, 2011 • 1996 Buick Skylark

0helpful

1answer

Starter problems for 88 ford aerostar van 7 passenger. how do i know its the starter or bad connection?

Test your battery and starter by doing a voltage drop test. Put one test lead of your meter on the neg side of your battery, one on the positive. Check voltage. Make sure that you are actually connecting to the battery itself and not the terminal ends. Should read 12.8-13.2. Keeping the neg in the same location move the pos to the terminal end, engage starter, meter should read above 10 volts. Continue testing down the pos wire to the starter, checking voltage, until you find less than 10 volts. If the voltage is good at starter, have someone turn key to the start position, tap starter with a hammer. if starter engages , replace starter.

Aug 19, 2011 • 1988 Ford Aerostar

1helpful

1answer

Gauge showing low output alt only 1yr old wondering if it could be regulator or batt or wiring

if you have access to a digital multimeter, connect the meter (set to volts) across positive and neg. terminal of the battery, should read roughly 12.6 volts, close to 10 volts, battery may be going out, also test the alt output, disconnect neg term and place negative lead to battery neg post and positive lead to neg battery cable (make sure meter is set to amps) should read near the rating, if both those, then you'd want to do a resistance test, (set meter to Ohms) disconnect battery and connect meter neg to either pos cable terminal or where the pos cable connects to the alt and connect positive lead to opposite of neg, should read next to 0, the check resistance of the ground by connecting meter between batt neg cable and body of alt.

- Spenser

Apr 04, 2011 • 1988 Ford F 250

3helpful

1answer

How do I replace the battery on my 06 uplander

Yes, you need to unbolt the support bar that is covering the battery. After that is removed, then there is a battery hold down which keeps the battery from moving in the battery tray. Remove one of the bolts from the bar and losten the other so you can just move it out of the way without taking it off completely. Also, before doing anything, make sure to disconnect the neg battery terminal first and then the positive. When reinstalling a new battery, connect the new one as the last step starting with the positive terminal and then the neg.

Hope this is helpful
Positive Feedback ALWAYS Appreciated :)

Mar 06, 2011 • 2006 Chevrolet Uplander

0helpful

2answers

I need to replace my alternator

You need to first take off youre serptine belt. Inspect that and generally its a good idea to replace. Next there is a electrical connection on the alternator. DISCONNECT the battery FIRST!!!!!!!!!!!!!!!!!!!!!!!!! then disconnect the connection on the alternator, there are a couple of bolts that attach the alternator to the engine. and then simply bolt on the new one, re-attach the electrical connection and then re-install the (new) belt.

Aug 20, 2009 • 1992 Honda Accord

1helpful

1answer

I ran my battery dead and now my cd player wont work, just the radio. I installed a new battery on my 2002 sunfirwe and now the cd player does not work. It has a cd in it but will not eject or play.

Betty,
Disconnect the negative battery cable at the battery for 10 minutes. Reconnect the terminal and recheck CD player.
Let me know and we can go from there.
Regards,

Feb 26, 2009 • 2002 Pontiac Sunfire

10helpful

2answers

03 vibe cd player will not respond

I blew a fuse controlling the radio, charging system, turn signals, heater fan, ,etc..this ran down my battery.

When I replaced the fuse, the CD player would not respond, but the radio worked.

I disconnected the battery for over 30 seconds, hooked it back up, and the time reset on the radio to 12:00 and the CD player works again.

Jan 23, 2009 • 2003 Pontiac Vibe

0helpful

1answer

Need advice on changing a battery on a 2000 VW jetta

I change the battery on my TDI by undoing the nuts in any order, positive first and then neg, or vice versa. If you happen to have a long wrench that can connect terminals, be very careful not to touch the other one, undo the neg first then. When you work on the positive pole do not touch any metal parts of the body, if you have not released the neg yet, otherwise you will see fireworks with the following fuse replacement.
When the batteyr is disconnected from the terminals the radio code will be lost. If you don't know your original radio code, you will have to go to the dealer and pay $105 for the code. Without that code the the radio will not work unless you have installed other than VW CD player

Jul 16, 2008 • 2000 Volkswagen Jetta TDI

Question 2

wtdash

Master 606 Answers
Posted on Oct 24, 2012

wtdash

Master

Joined: Mar 10, 2010

Answers

606

Questions

2

Helped

238952

Points

1884

Hi,
A '94 didn't have a stock alarm system that would engage the killswitch. If you/previous owner installed an alarm you should verify how to reset it b4 disconnecting battery.

Td

Testimonial: "so in theory the alarm itself will be a problem as opposed to the killswitch? i have the clicker and all, so i would still have to reset it, or would the clicker still be controlling the alarm and killsitch?"

Related Topics:

If i install new cd player and disconnect neg terminal on battery will this permanently engage killswitch?

1 Answer

wtdash

Add Your Answer

Attachments: Added items

Related Questions:

How do i reset the cd player/exchanger of my 2000 dodge neon es. The lights continuously blink since the battery was disconnected to clean the heater core.

03 chevy silverado aftermarket cd player

Alternator replacement.

Starter problems for 88 ford aerostar van 7 passenger. how do i know its the starter or bad connection?

Gauge showing low output alt only 1yr old wondering if it could be regulator or batt or wiring

How do I replace the battery on my 06 uplander

I need to replace my alternator

I ran my battery dead and now my cd player wont work, just the radio. I installed a new battery on my 2002 sunfirwe and now the cd player does not work. It has a cd in it but will not eject or play.

03 vibe cd player will not respond

Need advice on changing a battery on a 2000 VW jetta

Not finding what you are looking for?

1994 Corolla

How do i reset the cd player/exchanger of my 2000 dodge neon es. The lights continuously blink since the battery was disconnected to clean the heater core.

Ask a Question

Check Out the Latest Top Trucks Report!

Top Toyota Experts

ZJ Limited

Thomas Perkins

ROBERT GARCIA

Are you a Toyota Expert? Answer questions, earn points and help others

Manuals & User Guides

. 1994 Corolla Manual

Related Topics:

If i install new cd player and disconnect neg terminal on battery will this permanently engage killswitch?

1 Answer

wtdash

Add Your Answer

Attachments: Added items

Related Questions:

How do i reset the cd player/exchanger of my 2000 dodge neon es. The lights continuously blink since the battery was disconnected to clean the heater core.

03 chevy silverado aftermarket cd player

Alternator replacement.

Starter problems for 88 ford aerostar van 7 passenger. how do i know its the starter or bad connection?

Gauge showing low output alt only 1yr old wondering if it could be regulator or batt or wiring

How do I replace the battery on my 06 uplander

I need to replace my alternator

I ran my battery dead and now my cd player wont work, just the radio. I installed a new battery on my 2002 sunfirwe and now the cd player does not work. It has a cd in it but will not eject or play.

03 vibe cd player will not respond

Need advice on changing a battery on a 2000 VW jetta

Not finding what you are looking for?

1994 Corolla

How do i reset the cd player/exchanger of my 2000 dodge neon es. The lights continuously blink since the battery was disconnected to clean the heater core.

Related Topics

Ask a Question

Popular Questions

P0420 code on Toyota Corolla

Toyota Corolla Verso 2004 CD problem

Second fuse box location on my 2003 toyota corolla

Check engine light and trac off light on in toyota 2012

Hood latch will not close

Check Out the Latest Top Trucks Report!

Top Toyota Experts

ZJ Limited

Thomas Perkins

ROBERT GARCIA

Are you a Toyota Expert? Answer questions, earn points and help others

Manuals & User Guides

. 1994 Corolla Manual