SOURCE: 1983 Mustang C-4 transmission
that trnas will not bolt up and since you don't have a computor control the trans wount interface with the harness it requires which you do not have on your vehicle. please rate this solution
SOURCE: 1983 v6 is no fun
give me a welder and a set of gas bottles and i will fit anything into whatever you like.but to be honest i do think your biggest problem will be the wiring.want to really hot it up put a jag engine in.but its most likely worth more in its original condition.high compression engine and not subject to having to fit a cat.but you could still fit the manual gearbox though.OK for when your europeon cousins visit as most of us lot in europe especially spain and italy wouldnt know how to drive an auto,they are only for old and disabled people.plus they cost a lot of money extra to have when you buy a vehicle and thats only if you can get it in an auto,very few manufacturers build europeon cars in autos
SOURCE: 98 Mustang v6 - no AC
Make sure the radiator pressure cap is the correct one and that the hose is not soft--check the lower hose and heater hoses for softness as well. They should be firm, but not hard or cracking. The temperature sensor is reporting normal operating temperature, so it and the thermostat are working correctly (hot water would blow out of the radiator if it were stuck). Check the cooling fan for free turning and no noise. Check it's grounding connection. Check the fuse box for blown fuses to the fan and to the A/C compressor. Make sure all the relays and fuses are firmly pressed into their sockets. Check the A/C compressor clutch winding for resistance--should not read infinity. Does the blower motor for the heater/A/C run when either is turned on? The A/C switch on the dash may be defective.
Testimonial: "Excellent suggestions for diagnostic checks! Thanks!"
SOURCE: LOCATION OF THE FUEL PUMP ON A 1983 MUSTANG V6
If you have the mechanical fuel pump, the pump located at the side of the engine. And if you have the electrical fuel pump, the pump located inside the tank. Remove your backseat if there is a hole, if not, you need to bring it down the tank with a floor jack with the wood.. There are two bolts and two straps too. ok
129 views
Usually answered in minutes!
×