Elantra power windows work from door switches but fail from main

There are two fuses that cover the power windows, but if it is only one window, it is likely to be the switch, the wiring, or the motor on that particular door. An auto-electrician can diagnose. Videos may help.

Hyundai Elantra (XD; 2000-2006) fuses and relays

Fuse-Box.info https://fuse-box.info > hyundai > hyundai-elantra-xd-...

The fuse box is located on the driver's side of the instrument panel behind the cover. The location of the fuses in the passenger compartment: Hyundai Elantra ( ...

Have you checked the power window switch? They do go bad and need replacing (I have an LD Elantra and all the switches in the drivers' door are tired...)

it's working from the drivers side. i would assume the passenger switch is bad or there is a wire disconnected from the switch.

at the bottom and top of the switch there are retaining tabs. you can try to pop it out at those points with a flathead screw driver, but it is sometimes easier to just remove the door panel to get it out.

Replace the dirver's door master control switch assy.

the window switch just pops out of door panel.

you dont have to take the trrim off on this car look at the outline of the switch open from rear and pull forward then you can change the window switch/ Please rate my response thank you very much

First, check the drivers door to body wiring where it passes between the doors. I'd take the panel off and start from the inside and work your way through the part that travels inside the rubber cover to the car. These are notorious for rotting wires in that area, which will cause a large problem.

If the harness is ok, replace the drivers door power window switch assembly. If the drivers door switches are bad then none of the others will work either. I see this very frequently as well from people who use too much Armour All cleaner, or drive with their window down in the rain and get it wet(smokers usually).

1. Remove the switch from the door trim panel. 2. Check for continuity between the terminals. If continuity is not as specified in the table, replace the power window switch. POWER WINDOW MAIN SWITCH WINDOW LOCK SWITCH

Inspection: Connect the motor terminals directly to battery voltage (12V) and check that the motor operates smoothly. Next, reverse the polarity and check that the motor operates smoothly in the reverse direction. If the operation is abnormal, replace the motor.