Replace rear bumper brake light hummer h2 - 2008 Hummer H2

Since this is a brake issue, please take the hummer in to a shop and have it looked at. Please do not drive it until you do.

If the tail light goes out when the brake light goes on, you have a bad ground.

if someone added an aftermarket item to your lights, they may not work correctly, have it looked at by a professional who does that type of thing for a living.

THE POWER STEERING PUMP ON MOST OF THE LIGHT TRUCKS ANY MORE ALSO RUN THE POWER BRAKES, CHECK TO SEE IF YOU HAVE POWER STEERING LINES GOING TO AND COMING FROM THE BACK OF THE MASTER CYLINDER AREA. THATS THE HYDROBOOST ACTUATOR. REPLACE THE P/S PUMP AND FLUSH ALL THE LINES

<a href="http://www.sexyeditor.com" rel="dofollow">Best Savings Rates</a>

this is too good

Once you open the tail gate, you will see 2 torx screws going into the side towards the tail light assembly. Remove those 2 screws and the assembly will come right out. Let me know if you need anything else.

from the rear of the bumper

Hello, If the socket is not broken and the metal contacts are not melted, you should be able to reuse the socket. It just got scorched from the bulb reaching 1000 degrees in a fraction of a second. The Tungsten coil inside takes a lot of heat to burn it up. If you can scrape the char off of the contacts and install a new bulb, every thing should work perfectly. I see these sockets charred like this all of the time, even with a good bulb. If the socket is deformed, you can usually go to any parts store and ask them if they can find you one of these sockets. Most of the parts stores have books loaded with aftermarket companies that deal with just this type of scenario. I hope this info helps...

it can be easily changed by removing the plastic cover then u will see the light bulb, don't try to change it from the back, it wont open :)