Question about Cars & Trucks

1 Answer

Sharan wont start clicking behind dash

Sounds like a relay clicking in fuse box,engine turns just wont run.The wife said there was a bleeping noise coming from the dash when it first happened.I also noticed the dash lights where lighting up faint when trying to start like a bad earth.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Cars & Trucks Master
  • 85,178 Answers

It sounds like the battery has failed from the description your wife gave you.

Posted on Oct 18, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
Benimur
  • 6966 Answers

SOURCE: car will not turn over

Hi,

If I understand you right, the problem is the engine will not crank, that is turn over when you turn they ignition key to START. Having said that, might it be that the issue is with the starter system. The starter system is initiated at the ignition switch when the key is turned to start. At this point, the ignition switch then provides +12VDC to a starter relay (if the vehicle has got one) or direct to the starting solenoid. The relay is but a remote switch with slightly higher amperage capacity. The starter relay then engages and supplies +12VDC to the staring solenoid. The starting solenoid then performs two (2) functions. It provides the switching action (hundreds amps) from the battery heavy cable to the actual starter motor. The solenoid likewise pushes a small pinion gear along the shaft of the starter motor to engage the ring gear. The ring gear is of course on the edge of the flywheel which in turn is attached to the crankshaft.

Starter system problems could be corrected by:
1. check battery, battery cables and connections;
2. charge the battery if required;
3. clean brushes and guides of brush holders of the starter motor;
4. clean the commutator and commutator segments;
5. check/replace the armature or field coils if determined to be defective;
6. in some extreme cases it could be the drive pinion or the flywheel gear ring is defective.
7. often it is the big switch that the solenoid activates that looses contacts causing no +12V internally to the motor.
8. Most likely would be a defective starter relay or the IGN switch itself. Relative to this, you might try and check the connectors/terminals and electrical joints.

In the picture below, the upper portion is the starter solenoid while the one below it is the actual starter.
c9b6a69.jpg
Given the amount of work to overhaul a starter, you might consider just replacing it.

So recommended course of action is determine if there is +12VDC at the starter solenoid when IGN switch is turned to START.

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards.

Thank you for using FixYa.

Posted on Jun 04, 2008

  • 110 Answers

SOURCE: 98 accord wont start. lights flicker in dash and engine wont turn over

Have the battery checked.  You may have heard a fast clicking sound when the lights were flickering, if so it's coming from the starter solenoid.  If the battery is bad, have the voltage regulator and alternator checked also.  A bad voltage regulator or alternator will kill the new battery.    

Try starting with jumper cables, if that works, you can pull the battery out, take it to a auto parts store that will test it for free (most parts stores will do this).  If it's bad, you can put a new battery in and then drive straight to somewhere to have the charging system tested.  

Posted on Oct 31, 2008

  • 1 Answer

SOURCE: headlights flicker all the time

Hi, my name is ricky and im 24 yrs old and from Bronx, N.Y . I bought my 03 impala in 04 and i had the same problem in 2007 in which that clicking noise happens. The headlights flicker, and even the gauges inside the car would flicker at times. It has nothing to do with fuses or a relay, please dont spend money on that b.s. like i did..lol I will try my best to explain what i did so that you can save some money and time. READ EVERYTHING AND USE ADVICE AT YOUR OWN RISK.
1st of all - I went to a junk yard/auto salvage yard to find a USED part that i needed. Often there are good parts from cars that have been totalled.
2nd- What i asked for was a Body Control Module. This controls most of the electric issues you are having and costed me about 50 dollars compared to a new one that was over $200 and reached up to $500.
3rd- I went head first under the steering column and found where the BCM was located. Poke around to find it cause it is def. there, hidden well. It doesnt take special skill to remove it or find it.
4th-Replace the BCM, but be advised that after you do this, your car might not crank over.My car did crank over because i installed a automatic starter previously so i could have started it with the remote start.
5th- you MUST take the car to a chevy shop so they can Program your car to the body control module this costed me about $250.
All together this information has to help you in someway.
If you have further questions or would like to make a comment, then e-mail me at " gyalflexfameh@gmail.com "
I hope this helps...im not saying it is a 100 percent guarantee for you, but i had this same problem recently and this was the answer to my problem. By the way, never buy a american car again or a GM product for that matter...Kudos

Posted on Dec 19, 2008

Mike258
  • 1498 Answers

SOURCE: 1996 honda civic wont start

Hi Meadors,

The clicking sound you heard most likely the starter solenoid engaging the starter. Only in this case it's failing to engage the starter. This is a classic symptom of a low battery. Here's why.

In a perfect world, when you turn the key to start:

  1. the solenoid is fed 12VDC which engages an electromagnetic coil inside it.
  2. A spring loaded steel piston inside this coil reacts to the magnetic field. It is pulled against the spring. By itself this sounds like a loud decisive CLICK.
  3. The movement of the piston simultaneously pushes the starter gear into the flywheel and sends power to the starter via heavy duty contacts. The starter draws a lot of power.
  4. The starter spins, turns the engine, the engine starts, life is good.
  5. When the key is released, the solenoid disengages, the spring pushes the piston back, the starter gear disengages from the flywheel.
In our world, when you turn the key to start:
  1. The solenoid which draws it's share of power engages as before. Click.
  2. As the starter tries to spin, the power available is insufficient. It draws all remaining power, there isn't enough left to keep the solenoid active and it turns off.
  3. Since the starter isn't drawing power anymore, the solenoid re-engages and the cycle starts over. Click.
  4. The cycle repeats. Click. A series of rapid clicks. Same page?
While a dead battery is the prime suspect, there can be other causes. Things to do:

  • Check belts, specifically on the alternator.
  • Terminal connections clean and tight.
  • In the 'Let's not over look the obvious' department: Battery voltage?
  • Get a jump. Try a jump start.
  • If a jump gets you going, it is either the battery not holding a charge or the alternator not providing one.
Even new batteries can be bad off the shelf. Especially if they have been on that shelf for a while. They may show the voltage but not the amps. This is called a 'Surface Charge'.

If you don't have a voltmeter, what you need to do now is visit an auto parts store (not a shop). Most (in the hope of making a sale) will provide free testing of batteries and charging systems.

What you need is called a "Load Test" on the battery. It simulates the load of an engine being started. This will confirm the battery is good or bad.

Then with the car running, they need to check the voltage to the battery (they will know this). If it's not above +13VDC, the alternator is bad or not connected correctly.

And if it doesn't start, what better place to be?

Let me know what they and you find out by commenting.
Best regards
Mike

Posted on Jan 07, 2009

bunnydawg
  • 5158 Answers

SOURCE: 1995 Nissan Maxima. Clicking sound under the dash when starting.

next time that happens... have him turn the key while someone else smack the starter with a hammer (not hard enough to break the case). it should start... if it does replace the starter as it is failing... the clicking you hear are the relays ... semi normal sound

Posted on Mar 16, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why will my jeep not start


Likely that the "clicking sound" behind the dashboard is the IGNITION RELAY. Start by replacing the ignition relay (inexpensive and easy to replace).

Sep 06, 2014 | 2005 Jeep Wrangler

1 Answer

I have a 1998 GMC Jimmy, put a different engine from a 1996 gmc jimmy in it, its been running great and here about 2 weeks ago it started giving me problems, I put the key into the ignition turn it to...


the signal flashing is a bad hazard switch. they all brake. if you hold the flasher buton just the right way the noise stops. sounds like your dash is shorted with the flasher

Mar 13, 2013 | 1998 GMC Blazer

1 Answer

My 2003 ford expedition wont start all the lights and gauges turn on and a buzzing noise is coming from the fuse box


Do you know how to test automotive electrical circuits ? Using a volt meter an wiring diagram to locate problems ?
Free wiring diagrams here http://www.bbbind.com/free_tsb.html Enter vehicle info. year ,make , model and engine size . Under system click on engine , under subsystem click starting . Click the search button then the blue link . The buzzing sound you hear may be the starter relay , do you know what a relay is ? Behind the right side kick panel , this is where the front passengers right foot would be next to . Pull the plastic cover and behind is the central junction box. You can check for B+ voltage where the relay plugs in .
VEHICLE RELAYS Operation Diagnosis

Electric Testing Techniques You Need to Know

Ford F150 5 4 No Start No Crank No Communications Codes U1900 U2023


Jun 09, 2017 | 2003 Ford Expedition

1 Answer

Hi have trouble locating fuel pump relay switch i think it may need new fuel pump but trying the cheapest way first when i turn key it turns over like it wants to start but will not start if u pour fuel...


the fuel pump has 2 fuses 1 in the engine compartment fuse box and 1 in the fuse box inside dash. Also the fuel pump relay is located in the glove box on the passenger side their is 3 relays in there. If you put your hand on the relays and turn the key to the on position you should feel it click and then you will know which one it is. If you do not feel it then this is likely your problem but check the 2 fuses first.

Feb 24, 2011 | 1997 Chevrolet S-10 Pickup

1 Answer

No start condition new battery , good starter, turn key to start position light come on dash, go forward to start light go out and you hear click under dash area like relay, no power getting to starter....


no starter relay is always at the fuse relay box at the engine compartment. The relay that you hear is the relay for the accessories to turn off the power during starting position.

Feb 01, 2010 | 1999 Ford Windstar

3 Answers

Car won't start focus is clicking


I wonder if your battery is really in an excellent shape. The way you described seem to be non sufficient voltage for the starter solenoid to engage completely. Make a quick observaton by leaving the headlight on while cranking the engine. If no significant drop on the headlight brightness. Then your battery is assumed to be good. (a cold crank voltage shouldn't below 10V) Then the remained items to work with is either the solenoid or the starter or both. I believe the solenoid is piggy pack on the starter. Most autopart stores would test it for free of charge.

Jun 01, 2009 | 2000 Ford Focus

1 Answer

Engine like is on ,monday i heard i clicking noise in the fuse box under dash


That clicking sound could be a bad relay clicking on and off. Find it by putting a screwdriver handle to you ear and touching each relay until you find the one making all that clicking. Replace it.Good luck and be safe

Apr 22, 2009 | Ford Expedition Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

198 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

85178 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

john h

Level 3 Expert

22402 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...