Hi my 2003 honda pilot

Reset oil service light Honda Pilot. From years: 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012.
How do you reset oil service light Honda Pilot. From years: 2003, 2004, 2005.

1. Turn off the engine. Press and hold the SELECT/RESET button in the instrument panel and turn the ignition switch to run (one position before starting).
2. Hold the button for at least 10 seconds, until the indicator resets.
3. Turn the ignition off and then start the engine to verify the indicator has been reset.

How to reset oil service light Honda Pilot. From years: 2006, 2007, 2008, 2009, 2010, 2011, 2012.
Resetting the Engine Oil Life Display if maintenance service is done by someone other than your dealer, reset the maintenance minder as
follows:

1. Turn the ignition switch to the ON (II) position.
2. Press the select/reset knob repeatedly until the engine oil life is displayed.
3. Press the select/reset knob for about 10 seconds. The engine oil life and the maintenance item code(s) will blink.
4. Press the select/reset knob for another 5 seconds. The maintenance item code(s) will disappear, and the engine oil life will reset to 100.

All information is taken from the Honda Pilot owners manual.

most likely means a service is required , to check get the OBD codes read , this will tell you what the maintenance required is , i presume you've checked all the levels oil, coolant ,brake fluid,power steering fluid even washer bottle ?

Start when the battery load voltage change ... the lack of instantaneous voltage, all right, normal.

that can be a need for an oil change or tune up.. how long have you had it,and how many miles on the van

• With the ignition switch OFF, press and hold the select/reset button
• Turn the ignition switch ON, and hold the button more than 10 seconds.

It just means it time to change your oil. If it has been changed recently and you just want to shut your light off just hold down the trip reset button. While holding it down turn the ignition on but do not start the engine. keep holding the button down for approx. 10 secs. the light should start flashing and then go out. then release the trip reset button and turn the ignition off. and the light will be reset.

It is letting you know that a scheduled maintenence is due

to reset your maintenance light follow the following steps:
1 Turn off the engine.
2 press and hold the select/reset button in the instrument panel, then turn the ignition switch ON
3 hold the button for at least 10 seconds, until the indicator resets.

hold down the trip button. turn the key on. wait until it goes off .

I have the same problem and I read in the user manual that it flashes as a reminder to get oil changed. Depending on how many miles between changes it flashes different amount of times. Manual tells how to reset the gauge. Might be more than that but check your book first.