The wire from the horn is part of an imobiliser so it wont start replace wire it sounds like imobiliser battery or alarm pad if wont turn off
SOURCE: when you try to start
I had the same problem last week ---- turn key to "on" position and then press and hold red button on dash for 3-9seconds and the alarm will stop. engine should now start.
EVERY Toyota dealer I called did not know what to do nor could they offer any ideas.
I figured it out after hours of playing with different paths.
This one actually worked..........
SOURCE: My 2002 Nissan Pathfinder's car horn for the alarm stop working.
Just hold the lock and unlock button on your key until you hear the horn again. Then its activated :)
Testimonial: "Excelletn solution, was looking for solution for months, vvg418 is super, can't thank enough."
SOURCE: car wont start alarm light is blinking
yes factory alarm. there is a smal switch hiden under dasch board find it and turn the alarm of by reseting the boutton you can also open the driver side of car witt your keys
SOURCE: Car alarm stopped working.. Car wont start
the jetta has a faulty alarm system from the factory i have been working on one in my shop. the alarm moddule is inside the dash behind the light switch and has a 10 pin connector and a 6 pin connector. this can be bypassed if you disconnect both connectors and jump the two large wire on the 6 pin connectors, these wires operate your starter. the car will start and run but your alarm will no longer be active. the door locks and everthing else will still work. the only issue i am having is the factory radio isn't working because it is controlled by the alarm. but worse case scenario i can use an aftermarket radio if need be.
SOURCE: alarm went off, car wont start. reset switch??
Pull the battery cables, hold them together for 3-5 minutes, this resets the cpu in the car. That should fix it.
461 views
Usually answered in minutes!
×