SOURCE: Location under hood for fuel pump relay on 2002 Mazda Millenia S
JUST RELEASE THE PRESSURE AT THE FUEL PRESSURE TEST PORT ON THE FUEL SUPPLY RAIL THAT SUPPLIES THE INJECTORS, IT IS A METAL VALVE LIKE A TIRE VALVE, THAT IS THE FACTORY RECOMMENDED METHOD..
SOURCE: how do i replace the fuel pump in my 1993 mazda 626 2.5
1. Relieve the fuel pressure and disconnect the negative battery cable.
2. If not already removed, depress the clips on each end of the rear seat cushion and remove the cushion.
3. If not already done, detach the electrical connector from the fuel pump/sending unit.
4. Remove the attaching screws from the fuel pump/sending unit access cover and remove the cover.
5. Disconnect the fuel supply and return hoses from the fuel pump/sending unit.
6. Remove the attaching screws and the fuel pump/sending unit from the fuel tank.
7. Detach the sending unit electrical connector, remove the sending unit attaching nuts and remove the sending unit from the fuel pump assembly.
To install:
1. Attach the sending unit to the fuel pump assembly and install the nuts. attach the sending unit electrical connector.
2. Install the fuel pump/sending unit into the fuel tank with a new gasket and install the mounting screws.
3. Connect the fuel supply and return lines.
4. Install the access cover and the mounting screws.
5. Attach the sending unit electrical connector.
6. Position the rear seat cushion over the floor, making sure to align the retaining pins with the clips. Push down firmly until the two retaining pins are locked into the rear seat retaining clips.
7. Connect the negative battery cable, start the engine and check for proper system operation and for fuel leaks.
SOURCE: Mazda B2600i
are there any fault codes present? i was looking at the fuel injection diagram on autozone.com and the only thing i can see that controls injector pulse width is the pcm. are all the injectors open for 15ms? you should also check fuel pressure. if you want to look at the diagram, go to autozone.com. register and enter you car. select repair guides, chassis electrical and the wiring diagrams
SOURCE: need to know location of fuel pump relay
The pump is in the tank. Before you consider dropping the tank. Lift the carpet in the back seat above the tank. The older MPVs had a trap door which would access the pump with out dropping the tank. It is definitely worth a look. I changed mine in half an hour.
263 views
Usually answered in minutes!
×