Assuming that this Model has 4 Wheel Disk Brakes I will lead you the Best that I can. Remove the Tire, From there you will see a Large Disk with a "Caliper" Mounted on the top side that covers Both sides of the Disk. On the Back side of this "Caliper" on the Top and Bottom of it There is going to be a Bolt on the Top and Bottom. Some use Allen Wrenches and Some use Bolts or Nuts, Feel around and figure out which one you have. Remove these and Lift the Caliper Off of the Disk,BE CAREFUL WITH THE BRAKE LINE ATTACHED TO THE CALIPER AND DO NOT REMOVE THE BRAKE LINE! Remove the Brake Pads from the Caliper at this Point. On the Back of the Brake Pads that you just removed there should be Clips, Take these off the Old pads ans Install on the New Pads. Right where the Pads were on the Caliper there is going to be a Round Cylinder with a Large Hole in the Center, This needs to be Depressed back into the Caliper to get this Job done. On the Top of the Caliper there is a Small Bolt that is Round on Top and has a Small Hole in the Center Just like a Persons Head on a Nut. You MUST do the Next Steps Together to make this work CORRECTLY! Get a Wrench that fits the Small nut on top and Loosen it VERY LITTLE While you use a Pair of Channel Locks to Compress the Cylinder Back into the Caliper. You should see Brake Fluid come out of the Head in that little Nut. Once the Cylinder is Compressed Back into the Caliper Tighten the Little Nut Back down. Try not to let Air get Back into the Hole in the Nut that you are Loosening Or We will have a PROBLEM. So, Make sure you do BOTH of them at the Same time (Loosen nut WHILE Compressing Cylinder with Channel Locks). Install the New Brake Pads on the Caliper the Same way that they came off. Wipe everything off and keep it all Clean! Install the Caliper Back on the Disk and Replace the Bolts on Top and Bottom of Caliper. Get in the Car and Pump the Brake Pedal until it gets Firm and go to the Next one! This will work for all if you have 4 Wheel Disk Brakes. If you get two much air in the Lines the Brakes will go to the Floor and you will have to have a Helper Pump the Brakes while you Loosen the Little Nut on top of the Caliper. Message Back with ANY more Questions!
181 views
Usually answered in minutes!
×