Question about 1991 Jeep Wrangler

Open Question

Ticking noise 2002 jeep grand cherokee in engine

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 2002 jeep cherokee laredo

the only problem that vehicle has is with cooling fans is relay/module or electrical harness to module that burns up located behind and under right front headlamp assy must remove headlamp to access relay/module that is what powers up fan motor module assy.

Posted on Aug 10, 2008

Ad
  • 114 Answers

SOURCE: 2002 wj jeep grand cherokee p1756

The governor pressure sensor is the most likley cause however an inspection of fluid or debris in trans pan would be a good idea to make sure there's nothing excessive in it. Attached is a list of possible causes however the senor would be the most common.

POSSIBLE CAUSES

  • Powertrain control module
  • 5 volt supply circuit open
  • Check transmission fluid level and condition
  • GOV press sensor signal circuit shorted to voltage
  • GOV press sensor signal circuit shorted to sensor ground
  • GOV press sensor signal circuit shorted to ground
  • GOV pressure sensor signal circuit open
  • Sensor ground circuit open
  • GOV press sensor signal circuit shorted to voltage inside transmission
  • 5 volt supply circuit open inside transmission
  • Intermittent governor pressure solenoid
  • Internal transmission problem
  • Oil burnt or oil pan has excessive debris
  • Other transmission DTC'S
  • GOV press sensor signal circuit shorted to sensor ground inside transmission
  • Valve body
  • GOV press sensor signal circuit shorted to ground inside transmission
  • GOV press sensor signal circuit open inside transmission
  • GOV press sensor ground circuit open inside transmission
  • Governor pressure sensor (high)

Posted on Mar 26, 2009

  • 12 Answers

SOURCE: overhead console completely dead 2002 jeep grand cherokee laradeo

Check the fuses for the overhead console, could be that if not then the console needs to be replaced.....

Posted on Jun 05, 2009

  • 70 Answers

SOURCE: 2002 Jeep Grand Cherokee 2.7crd engine light/ no gear changes

your transmission is in "limp home" mode, the problem is one of the sensors on your transmission. you need to have an obdII scanner connected to read the codes stored in your vehicles computer. this will tell you which sensor has failed

Posted on Nov 25, 2009

Testimonial: "Thanks, will get that checked out"

  • 3640 Answers

SOURCE: 2002 jeep grand cherokee with 4.0 engine will die but restart

p0340 is the cam shaft sensor, this will cause it to cut off while driving, hardtime starting, p0351 is the ignition coil A primary/secondary curcuit mal function. p1391 is ignition system misfire, this could be plugs, wires, or coils. first of all have the cam sensor changed and it may correct the rest of the codes. when fixed turn light off with obd2 scanner. if you do not have one, then any auto parts store will erase the codes fo free of charge.

Posted on Jan 21, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Knocking sound in engine


which engine? "size"?
ever seen a $5 stethoscope.?
using it, you can find any source of any noise. easy.
ever do an oil change every 5k? on older cars , ?
using 10w-30 or 10w-40 oil? not 5w?

Sep 23, 2014 | 2002 Jeep Grand Cherokee

1 Answer

What would cause a Ticking noise in a jeep grand cherokee


Most time a ticking noise is caused by a valve lifter malfunction or a worn pivot on a rocker arm. if the noise appears to be coming from the valve cover (inside) that's usually where the problem is. Depending upon which engine you have the repair procedure will vary. (consult a haynes or chilton manual)
Before taking anything apart though many times a lifter noise will respond to a good engine additive like marvel oil or lucas engine conditioner. Neither one will harm the engine and it may quiet it down for you!
If you think my answer helped, please rate it. If you have another question or did not understand the answer, just ask.

Jun 16, 2010 | 2001 Jeep Grand Cherokee

1 Answer

I have a ticking noise coming from what I believe to be the crankshaft angle sensor. It goes in where the distributor use to go on the right side of the engine block. Is there anything special about...


No special rules or tools to replace. If you get a used part you will need to get a spacing shim that sticks to the end to correctly space it to the flexplate. Otherwise a new one should just unbolt and go right back together.

May 19, 2010 | 2002 Jeep Grand Cherokee

1 Answer

I have a 2002 Jeep Grand Cherokee Limited which had a bad water pump and overheated, waterpump has been replaced but when engine starts to heat up engine has a ticking sound ? Any idea what this is ? No...


Ticking can come from so many places I could write all day... Use a screwdriver or a long extension as a stethoscope and try to isolate the source. Best guess I can make without seeing/hearing it is either you cracked an exhaust manifold or a valve lifter is sticking (only a guess) If it's a lifter, you can add a quart of marvel oil and usually it will quiet down.

Feb 10, 2010 | 2002 Jeep Grand Cherokee

2 Answers

2006 Jeep Grand Cherokee just started making a clicking or rattling noise when starting up. The noise isn't audiable when driving. I've checked the oil level and it is normal. It is time for an oil change,...


so it goes away after a bit, that could be cause theres no oil on the top part of your engine, thats normal. wait till it gets older, it will be louder.

Jan 04, 2010 | 2006 Jeep Grand Cherokee

2 Answers

Oil pressure gauge reads normal when first starts. as it warms up, gauge goes to zero. If I rev engine, gauge goes back to normal.


Two things...when it reads zero, is there any engine noise (tapping or knocking)? After you rev the engine does the pressure read normal at idle and function normally, or does it go back down? Either way, you should not drive the vehicle 'till you have a mechanical gauge (yours is electro-mechanical) put on there and the actual pressure is tested. The condition may be a bad sending unit, a bad bearing or possible obstructed oil pump screen. The repair is obviously different for each one and the price is as well.

Oct 20, 2009 | 2002 Jeep Grand Cherokee

2 Answers

I have been told the ticking noise my engine is


these is an old fix, and yes it is ok to do this, but it is better to add a can of Berrymans Chemtool run about 25 miles and drain oil.

Apr 02, 2009 | 2001 Jeep Grand Cherokee

Not finding what you are looking for?
1991 Jeep Wrangler Logo

Related Topics:

210 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

85161 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...