Failed emmissions codes 0400-0443-0300

I need to know the fault codes that it has stored in memory. The are in this format PXXXX, the X's being numbers, the P stands for Powertrain.

Post a picture of why your car failed the tests and we can go from there... Geof

The DTC is for the cam position actuator sensor. That does not necessarily mean you need a new sensor but it may. Prices vary wildly depending on where you buy them, same with labor rates. The dealer will cost you over $100 per hour in some parts of the country, I do side work for $30 so you need to get a quote from someone localy.

Hello, you probably have a trouble code P0506 stored in the system, this will keep from passing test. real simple fix. the throttle body is dirty, this will cause not enough air around the throttle body. simply clean out the inside of the throttle body around the throttle plate and bore. you will need to use throttle body cleaner or carb cleaner

MIL status is error codes, but usually for pre 1995 vehicles. If you check engine light was on, then it would not pass emmissions. Since your vehicle is a 2000, I would suggest you take it by an autoparts store and have them read your error codes before you try to reset them. Make sure you write them down in the order they come off their scanner.

Yu can usually clear error codes by disconnecting your battery.

Hi,

Code P0741 = Torque Converter Clutch Circuit Performance or Stuck Off. This relates to your transmission only and has nothing to do with Exhaust emmissions.

If failed smog test, there must be an issue within your emmission system, e.g. sensors etc

You will need to have your codes read again, or have your vehicle properly inspected.


Cheers,

CHANGE SPARK PLUGS AND WIRES .AND AIR FILTER.IF YOU SEE CHECK ENGINE LIGHT FLASHING ON.CODE SCAN SEE WHAT FAULT CODE YOU ARE GETTING.

change oil and filter put a emission cleaner in fuel

If you have trouble codes stored in your cars computer for O2 sensors a fuse will not fix it. One or all of the O2's may need to be replaced. There are test that can be done to confirm which one.

Hello what you need to do is throw a fresh set off plugs in the motor go to your parts store ask to buy a bottle off emmission pass follow the instructions you should be okay goodluck please rate