Where do i plug in the progressive snapshot on a 2002 hyundai accent?

SOURCE: 2002 Hyundai Accent Problem

first thing i need to know is did the timing belt break?
second is are you sure you aligned the timing marks and after the belt tensioner was tight you rechecked to make sure the timing stayed where you had it.
next step would be a compression check to if a valve was bent whenchanging the belt
i have seen this happen and this engine is an interferance engine.
later paul

Johnny Massengill

• 345 Answers
• Posted on Jan 02, 2009

SOURCE: 2002 hyundai accent codes p1529 and p0734

P1529 means nothing more than the TCM (transmission control module) has requested that the ECM (engine control module) turn on the check engine lamp.
P0734 basically indicates that your transmission is slipping.
You need to take this car to an authorized repair center for hyundai cars. Replacing the filter and fluid on the transmission might save this transmission but I would be willing to bet that a total transmission rebuild is in order.

Good Luck

SOURCE: timing belt on my 2002 hyundai accent 1.6 liter 4cyl

DID THE BELT BREAK AND THEN IT WAS CHANGED. If so then you may have bent valve. IF NOT then vehicle may be timed wrong. Here is a diagram of your timing marks, http://www.2carpros.com/car_repair_information/tec_info/2002/hyundai/accent/2002_hyundai_accent_timing_belt_diagram_marks.htm contact if you need more help. Thanks for using FIX YA

SOURCE: Broken Hyundai 2002 Accent door handles

i have a 2005 hyundai both back doors would not open from the outside . after taking the panel off i found out that the handle is completely plastic and that it had broke in half because off stress . i removed the handle ( which was a pain ) and used quick drying epoxy on the crack . then i put a thin piece if aluminum on each side of the crack and used the same epoxy to hold it on . the next day i put the handles back on ( after letting the epoxy dry ) and it has worked perfect ever since. my next recourse , if it breaks again , is go to ebay . there is a seller if you type in hyundai door handles that sells 2 after market ones for $39.99. they fit 2001 to 2005 . i hope that this helps .

SOURCE: how do you remove radio from hyundai accent 1998

You have to take out the ash tray, and remove those two screws, then pop out the center dash trim. Careful, though, you have to take out a lot of the wiring inside of your center dash trim in order to pull it out for enough room to move the radio in and out. I'm doing this right now, actually..