The heater hoses are hot but blowing cold air out thermostat is working
SOURCE: Heater blows cold air when idle
Sounds like you may have a partially plugged heater core. You could flush this out separately, from flushing radiator & engine block. Diconnect heater hoses going to your heater core and clamp off, so not to loose coolant from engine. Now hook up separate hose to one side of heater core pipe and flush out with typical garden hose. Repeat procedure on both heater core inlets. Reconnect original heater hoses and test difference. You may have to add an additional litre of antifreeze. If this don't work i suggest changing heater core. Good luck.........Ron.
SOURCE: heat works on driver side, passenger side blows cold air.
Did you check your coolant level or was it low and you added to it at some point? If so the system my need to be bleed or worst case the thermostat is going bad.
SOURCE: heater only blows warm air.
The hoses from your heater core should be very hot to the touch. Check the hoses going to the core from the water pump. It should be very hot. The return hose should also be very hot. Now check the hoses going to the core. If they are not the same temp, then your heater control valve is not working correctly or the vacuum is not working. At any rate, locate the vacuum line going to the heater valve. Remove the silver bar on the valve from the plastic plunger arm. You will have heat all the time now if it was only a vacuum problem. You can fix it later when it's warmer out. BTW a 200* thermostat will make your heater even hotter.
SOURCE: The heat in my 1992 Jeep Wangler is not working.
Hi!
It
appears we have an Air lock scenario and you will need to perform a
system Bleed.
Park
the vehicle on level ground, when cold remove coolant filler cap,
start engine and leave to idle, turn heater on full and blower to
max. When engine reaches operating temperature watch and listen near
coolant filler, keep clear as gurgling and hopefully a boil over
should occur. Top up with very warm coolant and wait as it may do it
again.
Check
for heat inside vehicle if warm replace coolant cap but keep an eye
on temperature gauge as the ~Air lock may have moved on from heater
matrix/core so proceedure needs to be carried out again from COLD.
If
persistent boil ups/over attention must made in the cylinder head
or
gasket area, or possibly water pump?
Please
press the Blue button to appraise my FREE Efforts, Thank You!
Paul
'W' U.K.
SOURCE: Passanger side heater blows cold while driver side is hot
U will need to replace the pass side air temp control blend door acuator motor.
264 views
Usually answered in minutes!
×