RWD VECHICLES.YOU HAVE TO REMOVE REAR DIFFERENTIAL COVER THEN REMOVE THE LOCK BOLT FROM THE DIFFERENTIAL PINION SHAFT AND REMOVE SHAFT.THEN PUSH AXLES SHAFTS INWARD TO REMOVE THE C LOCKS AND REMOVE AXLE SHAFTS TO REPLACE BEARINGS. MAKE JOB EASIER YOU NEED A HAYNES REPAIR MANUAL OR CHILTON REPAIR MANUAL READ THROUGH DRIVE TRAIN CHAPTER YOU NEED TOOLS TO CHANGE REAR WHEEL BEARINGS YOU NEED LARGE SLIDE HAMMER WITH ADAPTERS IT ALL DEPENDS ON YOUR VECHICLE TYPE YEAR AND MODEL.
I think you can take it to the near car repair shop.
_______________
car keys replacement
SOURCE: Rear Wheel Bearing Repair; 2005 pontiac aztek
Remove the brake caliper
Remove the disc, (rotor)
Remove the 34mm nut on the axel shaft
Remove the three (3) bolts from the back side
You will need a wheel puller (three jaw will work well)
Place the puller over the hub and tighten, this will push the shaft out of the hub. Now you have to pull the hub assy. out of the mounting bracket. I found hitting each side,of the hub with a lead hammer to work well. Don't forget to disconnect the ABS senser on the back side of the hub assy.
Do not over tighten the 34mm axel nut when you install the new assy. If you use an impact whrench on it you will damage the bearing.
SOURCE: Rear wheel bearings on Hyundai Accent
no i do not believe they are press in there are held in by a seal try www.autozone.com to see if they have your car listed if they do you will be able to get a diagram showing you how they come a part.
SOURCE: how to replace rear wheel bearing on s type jaguar v reg
pretty basic the same and any other wheel bearing. But you need a hydraulic press, if you dont have one of those then their is just no way that you will be able to do it.
If it is newer than an 05 you need to take it to the dealership, because they need to hook up their computer and electronically disengage the rear parking brakes by putting it into service mode.
SOURCE: Procedure for replacing rear wheel bearings 2000 Forester
i'm assuming you don't have a hubshark,this is a tool that will alllow you to remove the bearing while the knuckle is attached to the car,you may be able to rent this tool at a auto prts store .if not you need to remove the entie knuckle,first remove the trailing arm bolt,then the lateral link bolt{long and stubborn bolt},disassemble the brake shoes and parking brake cable,abs sensor if equipped the knuckle to strut bolt{no marking necessary they are not eccentric} then you need a to use or borrow a press to remove hub and bearings good luck
SOURCE: how do i replace the rear wheel bearing on my peugeot 206
wheel off remove the tin cap in the centure of the hub undo the big nut put the wheel back on with just 2 bolts finger tight so you can pull the hub off.once the hub is off take the 2 wheel bolts back out.now look in side the hub were the big nut was and you will see a sir clip take that out.then use a socket and a bench vice to press the old bearing out.use the socket and bench vice to put the new bearing back in.
337 views
Usually answered in minutes!
One would need you to provide a vehicle & some description of issue,we guess very well, but only tothe extent we can
What if they don't have a straight axle & have to break the suspension loose & put the rear hub in a press? Need a vehicle here
Its a 1984 lincoln town car executive and has 4wheel disc brakes. I hear a popping noise comin from the left rear wheel area.
×