Camber Alignment specs 2000 Windstar

SOURCE: Would you allow someone to drill out the the

it is the only way to adjust the camber , normal procedure

Ned C Cook

• 3433 Answers
• Posted on May 27, 2009

SOURCE: Wheel alignment is off

Have the vehicle aligned at an alignment shop.

SOURCE: need cylinder head gasket torque specs.

looks like there is special sequence to reassemble and tightening, a quick note replace any bolts that have two punch marks.tighten as follows: x x x x x 10 4 2 6 8 x x x x x 7 5 1 3 9 torque all down to 15 ft lbs torque to 30 ft lbs plus 90 degrees. Good luck!

SOURCE: Too much camber, 89 Ford Escort GT

Sounds like an alignment problem. You need sensitive laser equipment to figure out exactly what is wrong. Normally, you cannot install these type of parts upside down or other items may not fit right.

Testimonial: "Thanks, I figured I would need the alignment."

SOURCE: hit a light pole in parking lot got bad alignment

Thats an impossible question to answer. First you must determine what is bent and then replace it. When the shop checks the alignment, thats when you will know if it can be aligned.