I need to find which two wires on my mass air flow sensor go to the iat sensor

Hi Chris.

p0304 = Number 4 Cylinder Misfire Detected

Faulty spark plug 4
Clogged or faulty fuel injector 4
Faulty ignition coil 4
Fuel injector 4 harness is open or shorted
Fuel injector 4 circuit poor electrical connection
Ignition coil 4 harness is open or shorted
Ignition coil 4 circuit poor electrical connection
Insufficient cylinder 4 compression
Incorrect fuel pressure
Intake air leak

The P0304 code means that the cylinder 4 is misfiring or is randomly misfiring. Start by checking for intake leaks an if no leaks are found the next step is to replace the spark plugs on cylinder 4.


p0102 = Mass or Volume Air Flow Circuit Low Input

Faulty mass air flow sensor
Intake air leaks
Dirty mass air flow sensor
Dirty mass air filter
Mass air flow sensor harness is open or shorted
Mass air flow sensor circuit poor electrical connection

Before replacing the mass air flow sensor, try replacing the air filter and cleaning the air flow sensor with low compress air or mass air flow sensor cleaner.
Reset code and drive vehicle.
If the code comes back, it may be necessary to replaced the mass air flow sensor.


p0154 = O2 Sensor Circuit No Activity Detected Sensor 1 Bank 2

Faulty Front Heated Oxygen Sensor Bank 2
Front Heated Oxygen Sensor Bank 2 harness is open or shorted
Front Heated Oxygen Sensor Bank 2 circuit poor electrical connection
Inappropriate fuel pressure
Faulty fuel injectors
Intake air leaks may be faulty
Exhaust gas leaks

Replacing the Front Heated Oxygen Sensor Bank 2 usually takes care of the problem.


p0113 = Intake Air Temperature Sensor Circuit High

Faulty Intake Air Temperature (IAT) sensor
Dirty air filter
Intake Air Temperature (IAT) sensor harness is open or shorted
Intake Air Temperature (IAT) sensor circuit poor electrical connection

The Intake Air Temperature (IAT) sensor is built into mass air flow sensor or in some vehicles mounted to the air filter duct housing. The sensor detects intake air temperature and transmits a signal to the Engine Control Module (ECM).The temperature sensing unit uses a thermistor which is sensitive to the change in temperature. Electrical resistance of the thermistor decreases in response to the temperature rise. The Intake Air Temperature signal is used as an input for various systems in the vehicle.



Hope this helps
FYT

http://www.autocodes.com/make/nissan

None of those , those are just the mass air flow sensor . If it had IAT sensor too , it would have 6 wires not four . intake air temp. sensor has gray wire and a gray with red stripe wire .

code p 0113 refers to intake air temperature (IAT) sensor --circuit malfunction===causes wiring open circuit / short to positive ---wiring short to ground ---ground wire defective --IAT sensor---ECM
the MAF ( mass air flow) sensor has nothing to do with the fault
the fault is in the wiring or the IAT sensor

It is not an ECM/PCM problem.
P0102 - Mass or Volume Air Flow Circuit Low Input
Possible causes- Faulty mass air flow sensor
- Dirty mass air flow sensor
- Dirty air filter
- Mass air flow sensor harness is open or shorted
- Mass air flow sensor electrical circuit poor connection
- Intake air leaks Tech notes Before replacing the mass air flow sensor, try replacing the air filter and cleaning the air flow sensor with low compress air or mass air flow sensor cleaner. Reset code and drive vehicle. If the code comes back, it may be necessary to replaced the mass air flow sensor

Hi there:
This code is set when the MAF (Mass Air Flow) meter is not sending the PCM the correct information. This can be due to a bad conection of the rubber intake hose between the MAF and the Throttle plate opening, a dirty air filter, a dirty mass air flow or a bad mass air flow.



Most programmer have you tie into the iat sensor in the mass air flow. this can cause the the iat sensor oto short out.


Hope helps.

P0103 HYUNDAI - Mass or Volume Air Flow Circuit High InputPossible causes- Dirty mass air flow sensor
- Dirty mass air filter
- Mass air flow sensor harness is open or shorted
- Mass air flow sensor electrical circuit poor connection
- Intake air leaks
- Faulty mass air flow sensor
Tech notesBefore replacing the mass air flow sensor, try replacing the air filter and cleaning the air flow sensor with low compress air or mass air flow sensor cleaner. Reset code and drive vehicle. If the code comes back, it may be necessary to replaced the mass air flow sensor.
P0112 HYUNDAI - Intake Air Temperature Sensor 1 Circuit Low InputPossible causes- Dirty air filter
- Intake air temperature (IAT) sensor harness is open or shorted
- Intake air temperature (IAT) sensor electrical circuit poor connection
- Faulty intake air temperature sensor
When is the code detected?An excessively low voltage from the sensor is sent to ECM.

The Mass Air Flow (MAF) sensor/Intake Air Temperature (IAT) sensor is located in the air cleaner case.
// // 0) preLoad.src = ctl00_cphLeft_chRepairTreeNav_tvTOC_ImageArray[i]; } ctl00_cphLeft_chRepairTreeNav_tvTOC_Data.lastIndex = 34; ctl00_cphLeft_chRepairTreeNav_tvTOC_Data.populateLog = theForm.elements['ctl00_cphLeft_chRepairTreeNav_tvTOC_PopulateLog']; ctl00_cphLeft_chRepairTreeNav_tvTOC_Data.treeViewID = 'ctl00$cphLeft$chRepairTreeNav$tvTOC'; ctl00_cphLeft_chRepairTreeNav_tvTOC_Data.name = 'ctl00_cphLeft_chRepairTreeNav_tvTOC_Data'; //]]>

The Intake Air Temperature (IAT) sensor is an integral part of the Mass Air Flow (MAF) sensor. Looks like this:

the IAT sensor is part of the Mass Airflow sensor. here is a picture of that sensor.

The intake air temp sensor is the one that is not the mass air flow. It should be a little 2 wire sensor in the inlet tube. The mass air flow is near the air cleaner, and is inline with the air inlet tube.

I assume you are looking for the wiring for the IAT because MAT sensors are no longer used..

here you go

black / white - PCM ground
pink - fused 12-volts
yellow - MAF signal
tan - IAT sensor signal
black - IAT sensor ground

manifold temp. sensors are no loner used.

I believe you are looking for the IAT "intake air temp sensor" which is part of the mass air flow sensor.

good luck

[email protected]