SOURCE: 2001 land rover Disco II td5 not starting - no fault
Check the crank and cam position sensors...sometimes they don't kick the SES light on until they fail. one of the main symptoms of the cam position sensor failing is the "no start, but cranks fine" issue. This happens especially when the engine has been driven and is warm. If the sensor has failed, the engine won't start at all, and everything else will seem fine..the part is usually cheap at the store, and usually easy to replace since it will be near the top of the engine somewhere. I'd start with that and see how it goes...The other sensor I mentioned is also critical in the timing of the engine the "crank sensor" if it fails, it may also cause that situation. The two sensors together tell the CPU where the cam and crank are in their timing sequences. If one isn't working, the CPU won't know where to fire what cylinder, so it just won't fire any of them. ie: No Start. I would replace them both just to be sure. Since you have checked everything else, and it cranks, I can't think of anything else at this point. Good luck. :)
SOURCE: disco 2 wont start
,slacken the injector pipes off then assistant cranks engine with throttle wide open ,as you see fuel start to appear at an injector tighten the nut ,as soon as you have about 2 or more bled out it will fire .easy to do
342 views
Usually answered in minutes!
Did you get rid of all the bad fuel or you just added good fuel to the bad one?
×