2000 chevy blazer braking problem

Measure the lenth of both rear ends. see iss all hardware will bolt up without fabrication. if its the same size it will work. But im afraid being a 4 wheel drive it will be geared lower then a regular pick up/ Drive shaft may work but if not it would have to be shortened or lenghthebed. alot of work. Brakes you could leave the non drum breaks on better stopping power. I honestly believe you would be better off just going to a scrap yard and find one very easy to remove and replave few hour job.

I HAVE 2000 BLAZER and the 3rd brake light works but the ones in the tail light do not work have turn signals and new bulbs but no brake light

YOU HAVE TO COMPRESS THE CALIPER PISTON BACK INTO THE CALIPER USING A C-CLAMP OR SIMILAR TOOL. USE AN OLD PAD TO DO THIS.

replace e-brake cables and more than likely both rear brake cylinders,shoes and drums

Common cause is the drums and brake shoes need to be replaced. When there no longer within the the specification for the brakes to work properly, the self adjusters will over adjust the brake shoes and you'll have the feeling of the rear drum brakes lock up as the shoes will bind up along the drums. Replace both Shoes and Drums and this can be done on your own will common tools and a simple brake spring tool that you can pick up at Auto Zone or Parts Source and both can give you the step by step instructions to replacing the rear brake system. Good luck and be safe.

Sounds like a likely possibility, the reverse method definetly did the trick in loosening the brake, but it may still be slightly applied, put it in a warm place when you can, or have a shop look at it indoors, it may need to be re-adjusted, or even just warmed up until the cable frees up again

Probably broke the neutral safety switch. Try putting the gearshift in neutral. If the truck cranks then, it is definately the switch. Try this and let me know if it helps :)

bleed the brake again. if the pedal goes to the floor with little resistance, then the master cylinder is your problem.
the shim is to depress the noise when you applied the brake. you can skip that, if the brake works without it.

Find a good shop and see if the parking brake ratchet assy is broke. This is common on chevy.. TY