SOURCE: 1998 528i bmw cam shaft sensor location
hope this helps .
http://picasaweb.google.com/mmm635/CamshaftPositionSensorsCamshaftPulseGeneratorsAsBMWCallsIt#
not the same year but should be same place.
SOURCE: Check Engine light on 1998 BMW Z3 roadster
yes the light is because of the gas cap being gone (sets code in evaporative emissions system), replace the gas cap, disconnect the battery for five minutes and that will turn of/reset the light, make sure u have the radio code before u do this, if u don't u will have no radio after the battery is disconnected..
SOURCE: I have 1998 bmw 528i, the problem is when the ASC
Check to see if your brake pads and rotors are in good condition. Or if you have replaced the pads yourself and have not reset the wheel sensors this would cause the ABS Antilock Brake System light and the ASC Automatic Stability Control light to stay on as the ASC uses the ABS brakes with computer assistance to control the traction of the car if not fixed it can affect your rev limiter and slow performance
SOURCE: Resetting brake warning light
Hi , if you turn the ignition on so that all the dash lights are on , do not start the engine and leave on for aprox 45 seconds the brake pad warning lights should go out, regards mark
SOURCE: 1998 bmw 528i battery died how to open trunk
You can jump your 98 528i from under your hood. On top of the center of your engine there is a positive (+) sign. You have to pry the cover open and there is also a negative ground spot to the left of that. Bmw is pretty smart!
1,007 views
Usually answered in minutes!
×