Question about 2007 Mercedes-Benz C230 Sedan

1 Answer

I was told that i need to replace the system battery pack what is that for and where is it located

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.


    An expert that got 10 achievements.

  • Mercedes-Benz Master
  • 85,160 Answers

You may have this posted in the wrong product category. Please select another category appropriate to the problem and re-post the problem so the correct expert will see and respond to the question..
This is for car and truck problems.

Posted on Oct 01, 2012


1 Suggested Answer

  • 2 Answers


Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My 04 chrysler sebring wont shift out of 1st gear and has reverse i was told its the trans ctrl solenoid. what is the best way of fixing this part how do i go about it?

the car is likely stuck in second as that is the default gear when there is a transmission issue.

Is the check engine light on? I suspect it is.

Have you checked for transmission codes? if so what are they?

There are several things that go wrong with these that are fairly simple to fix and cheaper than the solenoid.

To replace the solenoid pack (by the way I have never had this fix a transmission problem) you are going to remove just about everything on the drivers front of the engine compartment. The air filter housing, computers, battery, fuse boxes, etc. Then you will be ably to see the solenoid pack located on the front of the transmission. You will then need to remove the cooler lines and the input speed sensor from the transmission. The three bolts for the solenoid pack can be removed with a 10mm socket. A new solenoid pack can be purchased from the dealer.

I’m happy to assist further over the phone at

Mar 20, 2011 | Chrysler Sebring Cars & Trucks

1 Answer

Where is the thermostat?

It's located under the ignition coil pack.

Follow these instructions to replace the thermostat

  1. Disconnect the negative battery cable.
  2. Drain the cooling system.
  3. Remove the air intake tube, crankcase breather and PCV hose.
  4. Remove the ignition coil pack and bracket.
  5. Remove the upper radiator hose.
  6. Remove the ignition coil pack bracket.
  7. Unfasten the heater hose inlet tube bracket bolt and remove the heater hose inlet tube from the thermostat housing.
  8. Remove the three thermostat housing attaching bolts, then remove the thermostat housing and gasket.

Mar 06, 2011 | 1994 Ford Escort

1 Answer

How do I change the coil pack in my 2005 ford taurus

Welcome to Fixya.

Here's the procedure how to replace the ignition coil pack of your car.

Understand basic safety procedures. Any time you work on your Ford Focus, you should set the emergency brake and disconnect the negative, or ground, cable from the battery. Some mechanics recommend you isolate the cable to prevent accidental contact, which could spark a connection.
Release the spark plug wires from the Ford Focus ignition coil pack. You may need to pinch or press a release to unlock the wires.
Use a socket set or a small wrench to unbolt the ignition coil connectors. You also need to undo the capacitor electrical connectors. As you work, make note of which connectors go where--this pays off you when you reassemble the parts.
Locate the bracket that holds the ignition coil pack and the electrical capacitor in place. Undo the fasteners that secure them.
Separate the Ford Focus ignition coil pack from the mounting system. Replace the old Focus ignition coil pack with a new one. Verify the new ignition coil pack works with your engine, even if you use a universal ignition coil pack.
Reassemble the parts. If you have a Torque wrench, use it to tighten the ignition coil bolts with 7 inch pounds of torque (10 Nm).

Thank you for using Fixya!

If you need further help, reach me via phone at

Nov 19, 2010 | 2005 Ford Taurus

1 Answer

I have a 1996 ford ranger 2wd 2.3 engine. when i had the code read it came up with p301 #1 cyl misfire. I was told to replace the coil pack, Which coil pack should i replace? the one clostest to the front...

I would replace all of the coil packs. if one goes bad, then the others usually follow. if you don't want to, i would say the one closest to the front. but you can always try different ones by taking it back off and putting it where the other neighboring one is. and vice versa.

Aug 15, 2010 | 1996 Ford Ranger SuperCab

2 Answers

Hyundai sonata car not starting

There are some possibilities which you will have to check in this case:--
1) First of all check the power and voltage to the battery.with meter it will show exact 12 volt if the battery is charged.if the voltage is less get the battery charged at local auto repair shop.if the battery is internally drained and not getting charged then its time to replace the battery.
2) When you crank the car do you see spark coming at the spark plug? if no then its time to check the spark plugs and coil pack.if the spark plugs are not worn out and looks new then its time to check coil pack.the spark plugs gets power to spark from coil pack.
3) The other thing to check in this case is the starter solenoid of the car.if the battery is charged and you start the car then it gives power to the starter to start the car.but if starter is faulty or not connected properly then car will not start.
4) The other thing to check in this case is fuel in the car.if there is fuel in the car then check the blockages in the fuel pump if the fuel pump looks proper then check the fuel filter above the fuel pump.
5) If all the above possibilities mentioned above checked out OK/perfect then its a electrical issue and the wiring's in the car needs to be checked.the car gets power from the battery to get the wires from battery needs to be checked one by one.
Thanks. keep updated for any more can rate this solution and show your appreciation.

Jun 09, 2010 | 2001 Hyundai Sonata

1 Answer

Ford mustang - year 2000 - 3.8 liter The car is running but low power. It feels like it's down a cylinder. It is not running smooth. The ''check engine soon'' light is flashing.I've been told it's the coil...


Aug 30, 2009 | 2000 Ford Mustang

1 Answer

Coil pack needs to be replaced

Your car wouldn't have any spark at all if your coil pack was bad. And your car either has a distributor or its coil on plug meaning each spark plug has its own ignition coil.

Mar 08, 2009 | 1996 Toyota Camry

2 Answers

Thermostat location in the 2.5 ltr V6 model...

Follow your upper radiator hose to your engine, the housing it connects too should be the correct location. Merry Christmas! and God Bless!

Dec 26, 2008 | 1994 Mazda 626

Not finding what you are looking for?
2007 Mercedes-Benz C230 Sedan Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers


Level 3 Expert

85160 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides