Is this idle pattern normal?
Remove the air filter,spray with special spray( mass air flow cleaner) in spray can the Area round the Bodie throttle unit with engine off press ful throttle down spray and wipe the valve this spray is ok for any sensors, 2nd start and stay1500to2000RPM and spray in tothe inlet manifolt only for one 2 seconds repeat that 8 to 10 times and lisen to your idling .if you not resolvethe problem, You may have to look in the engine portion of the calibrationif not then update the PCM calibration to the latest one calibrationn. Oring of idle control valve damage or valve
SOURCE: Idle Problem when you slow down of come to a stop idle goes low
THis has happened to me in the past. My fix was to clean the throttle body. The problem began after my battery died. The computer was defaulted back to its original settings after replacing the battery. Once I cleaned the throttle body, everything was fine. This happened at about 85,000 miles.
SOURCE: idle too high on a 06 cobalt
when you clean it make sure that you hold the butterfly open so you can get the spots clean that need it. If there is anything in the way the butterfly will not close. Just a small bit of dirt will do this .
SOURCE: Oil Pressure Light Comes On after 10 min of Driving
You may not have put the right amount of oil in your car, your oil pressure sensor could be faulty, or you may have a leak.
By revving your engine, you're increasing the pressure and thus turning off the light and making the sensor think that it's at the correct pressure.
212 views
Usually answered in minutes!
×