Hello, My LEXUS ES 300 1998 will not start, the last time I started the car was on Christmas eve, and it's been very cold here in Denver. When I did run the car on Christmas eve my fuel light came on, but I did not stop to refuel. I did add two galloons of gas to make sure I was not out of gas, but that still did not work. Any ideas!! I have plenty of power.
SOURCE: 1992 Buick Park Avenue - car runs great..when it runs.
The crank sensor is located on the side of crankshaft damper/pulley it mounted on a bracket. However it think that you may have a map-sensor problem that's very common with this vehicle. The crank sensor is not hard to change at all. Good Luck get back in contact if you need more help
SOURCE: ES 300 servicing: Lexus Dealer vs. Toyota Dealer
no there is not really a downside dealers are good it doesn't really matter who does it but lexus is more familiar with lexus vehicles than toyota because they specialize in it but something like that is simple .
SOURCE: 92 lexus es300 knock sensor
Need to remove the upper and lower air intake manifold. There are two knock sensors for the front and rear pistons banks. If you plan to do this yourself it is about 1 to 2 hours. While you are at it, there is a short coolant bypass hose sitting in the same spot, replace it. Another problem with the knock sensor is the wire harness used to connect the two knock sensors into one connection sometimes wears out and contacts the metal on the engine causing false signals to the ECM, so replace this cable also.
Just did this last summer on my 99 ES300. Pretty easy.
DIYr
SOURCE: car starts and runs fine then dies
ya could be a bad filter. or maybe your injectors are getting bad.
SOURCE: How many O2 sensors on a 1997 Lexus ES 300?
according to the manual i have... it has three.... one in the exhaust manifold.... and two in the exhaust pipe..... slightly vauge on the exact location of the last two sensors... but looks like it is after the catylitic converter.
99 views
Usually answered in minutes!
×