Need to disarm alarm system so i can ship it to Alaska
SOURCE: disarm alarm system
MY 1991 CHRSYER TOWN AND COUNTRY VAN HAS ALARM SET, AND THE VAN IS TOTALLY DISABLED. I DID NOT EVEN KNOW THE VAN HAD AN ALARM. WE BOUGHT THE VAN USED, AND NO MANUAL WAS NOT IN THE VAN. PLEASE HELP WE HAVE TRYED NUMBEROUS ATTEMPTS TO NO AVAIL. HOW DO I DISARM THIS ALARM SET PERMANENTLY, OR AT LEAST TEMPORARILY?
SOURCE: disarming the alarm
Try this,I think this will work.Unplug the Remote anti-theft module in the right hand kick panel.It will have 2 connectors,one is 22 cavity connector and the other is 26 cavity connector.
Now best I can tell by looking at the Schematics you will have you take the wires from pin 11 PK/LG and pin 22 PK/YE in the 22 pin connector and pin 1 LG in the 26 pin connector and run these to a ground.Then leave the RAP module disconnected. This should keep your electric door locks working and disable the alarm.
SOURCE: I changed my Honda CRV 's battery and now my audio
did you look in the owners manuel or tey pulling the radio out some times they put it there
SOURCE: 2000 Chevy Impala, alarm remote issues
you should be able to however im not sure if it is associated with the on board system if all else fails reconnect it and maby change the batteries in the remote for a starting point
SOURCE: disabling alarm system on 2000 mitsubishi mirage
this is a long shot, put the key in the driver door, turn to unlock then try to start the car, some systems disarm when the key is used to unlock the car.
-
Press the UNLOCK button on the keyless entry transmitter.
-
Insert a valid key into the ignition and start the vehicle.
?ā¬Ā¢
To disarm the CTD system in the armed mode:
-
Press the UNLOCK button on the keyless entry transmitter.
-
Insert a valid key into the ignition and start the vehicle.
?ā¬Ā¢
To disarm the CTD system when activated, alarming mode.
-
Press the UNLOCK button on the keyless entry transmitter.
-
Insert a valid key into the ignition and start the vehicle.
47 views
Usually answered in minutes!
×