2004 rav 4 cd player plays cd's but keeps saying No Title on Display and doesn't show track playing or error messages

Check wiring maybe some of wires have worked loose.

Hi there:
When CD ERROR shows on the player display, there is a problem with the CD mechanism. It will have to be sent out or taken to a repair shop to have it fixed.



Hope this helps.

Something inside the cd player has broken and can most likely be sent off for repair but I don't know how much that would cost, but a new one can range anywhere from $500-$1,000.

will it play? you may have blown an internal fuse in cd player,

HI lisasmith566 IT is not a fuse problem .
the problem is your the CD part of the radio
must likely the cd is stock or more likely the cd drive motor is defective .
FIRST try pushing eject on radio and see CD comes out if not you need a new radio .

good luck vote

You can try and resetting the CD player, by removing the positive lead off of the battery under the hood and reattaching it, this should clear out any error that the cd player currently has in its memory

Yeah you need a new CD player common on those trucks but be careful the RDS radios must be programmed if get a used factory radio

Okay, I'm assuming that you were sucessful in resetting your radio code.
I'm also assuming that you have a CD player (which may not be the case).
The flashing clock also functions as an error code indicator. It should say something, indicating what the error is. You can't set the clock until the error is resolved (a disc stuck in the CD player, for example, on no disc in the CD when it's been told to play).
The procedure is as follows (which you probably know):
The audio system display usually shows the time when the ignition switch is in ACCESSORY (I) or ON (II). It shows the operation mode of the radio, cassette player, or optional CD player/changer when you operate them, then goes back to the time display after five seconds.
If an error occurs while operating the optional CD player or changer, the display will keep showing the error code and will not switch to the time display until the error is corrected. You can set the time only when the clock is displayed.
To set the hours, press the H (Preset 4) button while pressing the CLOCK (SCAN/RPT) button. Press and hold the H button until the hour advances to the desired time.
To set the minutes, press the M (Preset 5) button while pressing the CLOCK (SCAN/RPT) button. Press and hold the M button until the minutes numbers advance to the desired time.

If you don't have a CD player, or no error is showing in the clock read-out, leave a comment so I can investigate further.
Hope this helps you.

are they Burned or copied CD's? CDR, CDRW? cause if they are some radios will not read them and give error messages. if not try using a lazer lens cleaner CD, they sell them at most music stores, you may have lint or dust on the CD lens with summer weather, and pollen in the air and dust, CD player lenses take a beating, so get a WET lazer lens CD cleaner, and that should help fix the problem

Still under warranty?... check that.