Location to change camshaft sensor for a 2005 gmc canyon

Question edited for clarity.
Question moved to model category.

Crankshaft position sensor location - Colorado Fans

coloradofans.com https://www.coloradofans.com > threads > crankshaft-...
Dec 16, 2009 - Hey everyone.. do ya know where the crankshaft position sensor is located on our engines? It would be a big help if someone could point me ...

Crank Positioning Sensor Relearn - Colorado Fans
Oct 7, 2006
No start after replacing Camshaft Position Sensor
Mar 2, 2012
Camshaft Crankshaft sensor ' Chevy Colorado & GMC Canyon
Feb 22, 2015
Colorado won't start after replacing the Camshaft Actuator ...
Sep 11, 2012
More results from www.coloradofans.com
..

Here's a link.http://www.autozone.com/autozone/repairinfo/repairguide/repairGuideContent.jsp?fromSearchPage=true&pageId=0996b43f80cb3932&partName=Removal+%26+Installation&partId=0996b43f80cb3932 Here's the part.http://www.autozone.com/autozone/parts/Duralast-Coolant-Temperature-Sensor/2005-GMC-Canyon-2WD/_/N-jmtu1Z91shd?itemIdentifier=631217_0_18589_

camshaft sensor located above crankshaft pulley, the camshaft sensor mounted on the front timing cover above the crankshaft pulley.

The 5 cyl engine looks like it is mounted on top of the exhaust manifold.

P0300 random misfire, P0506 Idle control lower than expected, 8207,6505,9300 these are GM codes will the use P0300 and P0506. Here is the solution GM canyon and colorado are plaque with camshaft solenoid plugging up,weather you maintance the vehicle like a religion or you dont the camshaft postion solenoid gets plug and causes rough idle every where. Here is your fix there are time I have succesfully cleaned the out with a carburator cleaner or engine cleaner and reenstalled and it worked, there are time I ran I with a engine oil flush and It worked, you gor 2 options take it out and clean it out,and put it back in(clean the oil ports of the solenoid).or run a engine oil flush with a oil change. Now why did this happen and what are the camshaft postion for.It for emmission it took place of the EGR has nothing to do with performance just emmission and headaches

yes, the filter is on the frame rail on the left side (driver side)at about the back of the drivers seat

this is set from camshaft and crankshaft sensor, always check engine oil for the right vescocity and change oil if necessary to avoid this dtc set

It is a 7/8 ths Sized Wrench needed for it and you Simplt Unplug it and remove it and replace it. If you see a Problem with this Method , there IS a SPECIAL SOCKET for 02 Sensors and Same Procedure just with A Socket / Extention / Ratchet.

located in the exhaust system

you might have the brake shoes adjusted out too much, back them off a little bit and far as the sensor goes, its located on the fuel rail where the injectors are.