Air bag light fault on mazda bt50 whats wrong

should be the engine light blinking the code flash

paper clip trick on the diagnostic port
no information on 64

if you have an air bag fault needs the obd2 diagnostic reader
to locate the fault ,, fix ,, then reset the srs system

The car should still be under warranty if a 2014 model so you should be taking it to a dealer to have it checked and rectified.

Code 31......Side Impact Air Bag Sensor Connector Poor Connection Passenger's Side

Just came across the site you need! Very helpful looking so I think you'll find your answer there, although you did not say what year. Go to this link, which says you can download for free:

http://www.shareol.com/Free-download-MAZDA-BT-50-BT50-2011-2014-WORKSHOP-SERVICE-REPAIR-MANUAL-ebooks/
http://www.shareol.com/Free-download-MAZDA-BT-50-BT50-2011-2014-WORKSHOP-SERVICE-REPAIR-MANUAL-ebooks

A common fault with the Mazda BT-50 / Ford Ranger is the ECM. The glowplug light and engine light won't come on. But if you cycle the key many times and those lights come on, the engine will start. In that case, the fault is most likely the engine ECU. The repair is worth approximately $1,200

air bag systems are very dangerous one wrong move and you deploy air bag i suggest you leave this to a dealer or pro to do this job

http://www.filekeeper.org/download/bt50/MAZDA%20material%20for%20technician/BT-50_en.pdf

This is a training manual and is just as good as the workshop manual... Good luck

Check the Air Bag Indicator Light. When you turn the car on it should stay on for 6 seconds and then turn itself off. If a fault is detected in the system operation check, the indicator light will either fail to light, stay on continuously or flash. The flashing may not start until up to 30 seconds after the initial systems check.

If there is a fault in the system AND the air bag indicator light fails to light then an audible tone will alert you- it will be a set of 5 chimes (bells/beeps) five times in a row.

Have the Air Bag serviced and the indicator light bulb changed. Since the dash will be off in order to change the bulb, I would have all of the other dash lights changed at the same time. If one goes out, others will surely follow.

Good luck!

Corri R. / Service Writer

the srs light comes on once the bag explodes however after installng the bag you have to also instal the relay which triggers the air bag or the light stays on problem is not in the bcm

The air bag module monitors all of the electrical circuits of the air bag system. If it detects a fault in any of these circuits, it will cause the air bag light to come on. If it's flashing, count the number of flashes between pauses, this should be the diagnostic code the module is telling you what is wrong with the airbag system (or you can use a scan tool) The only way to keep the light off (besides removing it from dash) is to repair the fault, you can clear the code with the scantool, but it will come right back on if it still sees the fault.