Where is the pcv valve on a 2002 V8 Lincoln LS?
SOURCE: 2002 LINCOLN LS V6 3.0 PCV VALVE LOCATION
it is down under the intake manifold. the intake manifold must be removed to get to it. this vehicle is known for developing a vacum leak in the elbow hose that connects to pcv valve, so ive done a few.
SOURCE: 2002 LS: aHow do I fill radiator in my V8 Lincoln LS...
First- to drain ,you can reach the drain valve,from the pass side,if you lay on the ground and reach up to the radiator. You do not even have to raise the vehicle up
Second- mix Yellow GO5 Coolant about 50/50 or 60/40. Do not use Green in a Ford or Orange GM
To Fill- Remove the front two plastic screw type buttons,from the engine cover
-Remove the cover
The radiator cap is on the front of engine,on top,it is plastic
Remove cap and that is your fill point
Run engine to warm and get thermostat open,as you would with any vehicle
Top off coolant,replace cap
VERY IMPORTANT-next to the Power Brake Booster,and just under it,is a BLEEDER HOSE;to let air out of system. Turn screw slot ,only a little,DO NOT REMOVE SCREW. When coolant runs out close.
Fill-Degas Bottle,to full line,with coolant.
Check the next couple days on resevoir level ( Degas Bottle)
SOURCE: were is the temp sensor on a 2002 lincoln ls v8
On the intake, Near the top radiator hose inlet, Note this model has 2, 1 Runs the guage, The other tells the pcm what temp the motor is for strategy. DO NOT REMOVE THIS WITH VEHICAL WARM OR HOT. IT WILL SPEW COOLANT IF YOU TRY, Allow vehical to cool all the way, And this is a very easy repair :) Good luck, God bless
945 views
Usually answered in minutes!
×