SOURCE: Starter removal - 1994 Isuzu Trooper
pull the starter away from the bellhousing and turn the drive end upwards then it will come out from the engine compartment tight i know but i have just done mine so i know it will come
SOURCE: 2000 isuzu Rodeo wont start
Could be your neutral safety switch, or it's not all the way in park. Broken or loose wires in the starting circuit. Inspect all wires and connectors at the battery, starter solenoid, and ignition switch. Or your starter pinion is jammed in the ring gear. Remove starter and inspect. Last but not least, your engine is seized. You don't want that one. Good luck.
SOURCE: how to remove starter from 1998 isuzu rodeo 4 whl drive 6 cyl?
disconnect the battery first. remove the 3 bolts connecting the starter the the bellhouseing, the remove the wires. install in reverse order
SOURCE: 2002 isuzu rodeo won't start
Good day;
the clutch switch is located on the clutch pedal support, if you put your hand on the clutch pedal run your hand up and the switch will be at the top. now if you are going to replace this switch I would try to adjust the switch first the amount of time it takes and this would confirm that it's the switch. ensure clutch pedal is fully returned, disconnect the electrical connector from the switch. loosen lock nut and tighten clutch switch by hand until switch is firmly against clutch lever. back the switch out 1/2 turn, the switch plunger should extend .02-.06" (.5-1.5 mm).
hope this helps
Cheers
SOURCE: where is the thermostat for a 2002 isuzu rodeo?
The thermostat is located at the end of the top radiator hose on engine.
97 views
Usually answered in minutes!
×