Question about 2004 Chevrolet Express

1 Answer

2008 mitsubishi eclipse 2.4 sepentine belt routing need to find a way to by bypass the AC

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 373 Answers

You got to buy a shorter belt serpentine belt that bypasses the AC unit most car have a diagram showing whit and whit out AC.

Posted on Sep 18, 2012

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 491 Answers

SOURCE: need to re route the belt . by bypassing the

On some models installing a non A/C optioned cars belt will do the trick due to it's shorter length.
If you can get a look at a non A/C car the same as yours....you can check if a shorter belt will do....or if it uses an extra idler pully on the belt system to make up for "no A/C compressor".

Posted on Aug 25, 2009

Ted Schore

  • 7353 Answers

SOURCE: My AC compressor went out on my 2004 Chevy Blazer.

its the same. but a different pulley takes place of the a/c compressor. I know DORMAN makes a few "bypass pulleys" to do this, but dont know if they make one for your truck. at the worst... you will need to get a pulley and bracket from the dealer for a truck without a/c . as long as your a/c pulley bearing is ok, you can let the belt run there.

Posted on Oct 14, 2009

scottjenks13

  • 17 Answers

SOURCE: I need the serpentine

scottjenks13.jpg

I hope this helps.

Posted on Feb 18, 2011

joseph cayo

  • 192 Answers

SOURCE: i have a 2007 impala lt 3.5l which the ac

I don't know of any way to by-pass the A/C compressor or any component in a serpentine belt system; but, you can unplug the compressor clutch (at the nose of the compressor, behind the pulley), then the compressor will not turn and the pulley just acts as an idler.

Posted on Sep 03, 2011

Mike Ceslow

  • 200 Answers

SOURCE: routing diagram for 98 gmc suburban sepentine belt

should be diagram on top of rad cover if not start with crank and go around water pump with back side of belt if its the rite belt can only fit one way

If you need further help, I’m available over the phone at https://www.6ya.com/expert/mike_9693b5ad75773352

Posted on Sep 01, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2008 Mitsubishi lancer radio from loud squealing noise


What is causing that irritating noise? ' DSMtuners

www.dsmtuners.com > ... > Articles: Miscellaneous
Jun 1, 2009 - 2 posts - ‎1 author Check the ECU power relay in the console, under the radio. ... You hear a loud clicking type noise from under the hood when you try to start the car. .... You hear a squealing, grinding, or rubbing noise in the lower timing belt .... The Mitsubishi Eclipse, Eagle Talon, Plymouth Laser, Mitsubishi Galant VR-4, ... LOUD squeak when turning steering wheel (Video Inside)
22 posts
Mar 5, 2011
Why does my alternator belt squeal so much on initial ...
25 posts
May 14, 2010
More results from www.dsmtuners.com

Lancer Troubleshooting [Archive] - evolutionm.net

www.evolutionm.net/forums/mitsubishi-evolution-forums/f-203.html
NEED RADIO HELP! ... Help not start Lancer GT 2012 EngineOverheating STOP SAFELY warning on ... AC ISSUES 2011 Mitsubishi Lancer ES · 2008 Lancer GTS no start please ... 2011 lancer no sound · Driver/Passenger side floor squeaky? ... plastic piece of rear shelf rattles a lot · Very loud noise on Lancer ES 2008 ...

Dec 03, 2015 | 2008 Mitsubishi Lancer GTS CVT Sedan

1 Answer

What is the correct 2007 sonata sepentine belt routing i installed a new altenator but aqm having trouble?


If the belt is tight, then it was probably routed around all the pulleys correctly.

Aug 10, 2014 | 2007 Hyundai Sonata 2.4

1 Answer

Looking for the size of the sepentine belt to bypass the ac


Perhaps get yourself a a/c bypass pulley...it replaces the one on the a/c...so you can simply use the original belt ...check ebay or your local parts store

Sep 30, 2013 | GMC Envoy Cars & Trucks

2 Answers

How to bypass the ac pulley on a 2003 hyundai sonata


2008 Hyundai Sonata 2.4L bypassed the AC compressor using the above routing picture and used Duralast 805K6 belt from AutoZone.
4_17_2016_5_44_20_pm.jpeg

Sep 03, 2012 | Hyundai Santa Fe Cars & Trucks

1 Answer

Eclipse. Timing. Diagram


For all types of
Timing belt routing diagrams for cars and trucks?

Click the link below:---
http://technoanswers.blogspot.com/2011/10/timing-belt-routing-diagrams-for-cars.html--------This will help.Thanks.

Feb 11, 2012 | 1996 Mitsubishi Eclipse

1 Answer

2000 mitsubishi eclipse belt routing


Below is a link with multiple diagrams from different angles showing the belt routing on your 2000 Eclipse. Best of luck and thank you for using Fixya!
Greg
2000 Mitsubishi Eclipse Serpentine Belt Routing

Dec 29, 2011 | Cars & Trucks

2 Answers

I need a Diagram on the Serpentine belt for an 2002 Eclipse. I need to know how to bypass the AC compressor.


The compressor cannot be by-passed, but you can disconnect the compressor clutch by disconnecting the two wire connector at the compressor; then the compressor pulley is just an idler.

Jul 30, 2011 | 2000 Mitsubishi Eclipse

2 Answers

I posted a question yesterday and received two responses. One didn't answer my question and the other answer has been disputed by an auto parts distributor. I have a 1988 Mitsubishi Mighty Max 2.0 with a...


i have checked with a friend in Kenya and if you need to, you can make up an adjusting bracket for the alternator(for belt adjustment)
and remove the ac.NO PROBLEM.as when they go wrong they also take them off, when fitted. hey guys,this is a world market,its not just the good old U.S.A.that has electricity.......mind you,only 2/3rds does.....

Sep 09, 2010 | 1988 Mitsubishi Mighty Max

2 Answers

2004 Taurus: i want to bypass the a/c unit...


get new sepentine belt #795k6 from advance auto parts also belt tensioner tool route belt exactly the same just omit the a/c unit this will work

May 18, 2010 | 2004 Ford Taurus

2 Answers

Need a sepentine belt routing diagram for a 1995 bmw 740I...


Any good auto parts store has a serp belt routing picture chart for each car

Aug 12, 2009 | 2007 BMW 750Li Sedan

Not finding what you are looking for?
2004 Chevrolet Express Logo

502 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...