My corrolla 94 tail brake light switch stays on all the time
Normally this is caused by a problem with the brake light switch. If you don't take care of this soon you will have a dead battery, so try this. Look under the dash at the brake pedal. There will be a switch mounted on the backside of the pedal/arm that has a push button switch inside. Have someone stand behind the car and check to see if the brake lights go off when you pull the brake pedal away from the switch toward the driver's seat. If they do, then you need to turn the outer housing of the switch a little bit to make it pull away from the brake pedal when the pedal is in its resting position.
Sorry, I can't remember which way to tell you to turn it but a few turns should be all that it takes. If that doesn't work then you may need to replace the switch but they rarely fail.
494 views
Usually answered in minutes!
2001 toyota corrolla timing chain engine seized up
i have 94 yota pickup 22re and have no brake lights so i jumped a wire from the brake light pedal switch to the tail lights and they didnt get brighter also if i go through 6" of water the truck dies and wont start for about ten minutes you can crank it over but it will not start
×