Im not getting any power from my ignition to start my car,but lights radio etc.. is all working I need Major HELP.
Ok..
Your vehicle is equipaded with Factory Anti Theft System.
Called Pass key II . If the mechanic found the Code
Pass key error....
Is there a few test to Do. to know exactly the problem.
1--- check if the Old and New key Are equipaded with a Little thing (Chip or Ressistence) in the center of the key.
If not you need a key with the chip. and the correct Ohms.
2. If you just replace the battery,
Full charge the battery Attemp to start the vehicle and leave the key in run position for exactly 11 Minutes, Them turn the key to off position for 30 seconds and try to start, if the vehicle start . you did the prosses to program the key.
If the vehicle not start.
Some times this procedure will require Up to 3 times to setup.
Or more with intervals of 30 minutes,, But if not start.
Remove the lower cover of the steering column. and the the Connector orange with 2 white wires shielded with a orange cover.
NOTE.. Be sure to not Confuse with the Yellow wires and connector, They are for the AIR BAG. Dont use a Convencinal Test light on any of the Mentionated wires....
After you find the wire and saw everything ok.
3-- You will need to remove the Ignition Lock cylinder.
The ignition lock cylinder is use 2 white wires shielded with orange cover, On 90% of the cases one of the wires come broken. and the ECM loss the comunication with the Chip incrusted in the key..
2,129 views
Usually answered in minutes!
yes security light is flashing,but i have done no repairs except got new battery and a spare key made because a guy put his diagnostic tool on it and it said, pass key error or data key error something like that,but it still does the same thing
Hi...
Ok.. The security light is flashing?. You did any repair on in the steering column or ign. cylinder.?.
Letme know.
×