04 pontiac grand prix remote

THe dealer would need to do that.

I have programmed my 2003 Pontiac Grand Prix remotes without going to dealer. Cadilac dealer could not for some reason, but I was able to. I don't know if your Olds is similar.

as long as you dont have auto /remote start the following link tell how to program the remote if remote start need dealer to reflash fob
How to Program Keyless Entry for 2005 Pontiac Grand Prix eHow

Is the battery good in the remote? Is the remote working? Did the car come with keyless remote?
If you stop by a big box part store they have a tester to check the remote. Sometimes when the battery is replaced there is a solder joint that brakes.

Here's what I found. Go to this page and select 2006 Grand Prix - http://www.programyourremote.com/classified/Browse.asp?cid=273
You can't program I guess, sorry

try programming the remote again, here is how u do that. if this doesn't fix the problem the remote may be defective, if you need a new one try ebay, they are very cheap to buy there.

.

Note: Existing keyless remotes will be erased with this procedure.
Existing working remotes will have to reprogrammed also.
1. Locate the programming connector wire located in the RH trunk area.
You may have to pull back right side trunk trim on trunk wall to locate
the single black/white wire.

2. The programming connector wire should have one termial in the plastic
connector on end of black/white wire. Ground the terminal in the connector
to a nearby bolt or trunk latch.
Leave connector wire connected to ground through out procedure.
3. System will now lock and unlock doors automatically to indicate
programming mode has been activated.
4. Press any button on keyless remote. System will respond by locking
and unlocking doors one time to indicate successful programming.
5. Repeat step 4 for to program any additonal keyless remotes including
and existing keyless remotes. Do not remove ground wire between
programming of keyless remotes.
6. Disconnect programming connector wire from ground to exit programming
mode.
7. Test keyless remote(s).

This has to be taken to the dealership. The tech will hook up their IDS computer to the car to pull the code. Once they have the code they can then access and re-program the keyless remote.

I just had to replace mine and sounds like the same problem. At the local O'Reilly's they have a display that shows if the RF from the buttons are working, if you can find one of those. I tried cleaning under the pad and nothing worked I think this is a common problem from what the local dealer tells me. I had to push my old buttons harder and harder to get it to work until they did not any more. About $175 to replace and program at my local dealer.

The rke on 06 pontiac only can be programed using a diagnostic scan tool or Tech 2.
Conect the scan tool to the vehicle. turn key to on position.
Select 1 body, 2 them select special funtions
3 slect program key fob,
4 select the number of key fob you want to program.
5 Press and hold the lock and unlock key simultaneous. about 15 seconds
The power lock cycle confirm the remote is programed.

Yes...

1) Remove the "MALL PGM" fuse located in the glove compartment (see owners manul for location)

2) Turn ignition switch to "Accessory" then "Off" then back to "Accessory" witin 1 second. (accessory is opposite the forward direction key is normally turned for starting the vehicle)

3) Plug in drivers side seat belt.

4) Open and close a door (will hear a chime indicating in program mode.)

5) Press and hold both the "Lock" and "Unlock" buttons on the Fob and wait at least 7 seconds (may take longer) you'll hear a chirp or the horn will sound.

6) repeat step 5 for all other Fobs.

7) turn key to Off and replace fuse.