REMOVAL 1. Remove the watershield. (Refer to 23 - BODY/DOOR - FRONT/WATERSHIELD - REMOVAL) 2. Remove door glass retaining clips and secure the window in the up position using masking tape or equivalent(FRONT DOOR GLASS CLIPS). 3. Disconnect wire connector from power window motor, if equipped. 4. Loosen screws attaching front and rear window guide rails to inner door panel (FRONT DOOR MANUAL WINDOW REGULATOR - TYPICAL). 5. Remove screw heads on guide rails from key hole slots in inner door panel. 6. Loosen screws attaching regulator to inner door panel. 7. Remove regulator from inner door panel. 8. Extract rear guide rail through inner door panel rear access hole (FRONT DOOR POWER WINDOW - TYPICAL). 9. Extract front guide rail through front access hole. INSTALLATION 1. Insert front guide rail through front access hole. 2. Insert rear guide rail through rear access hole. 3. Place window regulator in position on inner door panel. 4. Place screw heads on guide rails in position through key hole slots in inner door panel. 5. Tighten screws to attach front and rear guide rails to inner door panel. 6. Connect wire connector into power window motor, if equipped. 7. Install door glass. 8. Verify door glass alignment and operation. 9. Install sound shield and door trim panel DIAGRAMS CAN BE FOUND ON JUSTANSWER,COM
SOURCE: Remove inside panel pass.side door of 2001 Dodge gr.caravan sport
1, Disconnect the able from negative terminal of the battery.
2. Pry the courtesy light from the door trim and disconnect the wire connector..
3. Remove all door trim panel retaining screws and door pull armrest assemblies.
4. Remove the door switch panel and the control switch panel and the control switch assembly.
5. On models with memory seats/mirrors, use small-flat bladed pry tool to remove and disconnect the wire.
6. Grasp the trim panel lift up and pull out to detach it from the door. Disconnect the inner door handle lock rod from the handle. Unplug any electrical connectors remaining and remove the door panel.
7. To install, connect the wire harness connectors and place the panel in position in the door. Press the trim panel down into place until the hooks are seated.
8. Install the armrest/door pulls, the courtesy light and the window switch'
9. Reconnect the battery
Also. You will need star pattern drivers to remove the window and motor from your door. If you have all the equipment it should only take you 1 hour.
SOURCE: 2002 dodge grand caravan sport side window fell off the track
Front door, or sliding? There are several screws around the outer edge of the sliding door panel, then pry or pull the panel off, there are push type fasteners. Do this in a warm area, plastic may break when cold. The front door is a little more dificult, but doable if you have to. Let me know if this helps.
SOURCE: Serpentine belt slipped off. I need a diagram
How's this.
Testimonial: "Awesome. Thats the one I thought it was, can't get it to move though on account I can't get a wrench on it. theres no room to get my hands in there!"
SOURCE: 1999 dodge caravan fuse box map/diagram
Under the hood. Under the cover for the fuse box is a map of locations
799 views
Usually answered in minutes!
×