Anyone know what this could be?? The radio turns on but no sound and when a cd is in the cd player it says its playing but no sound what so ever. NONE!!! any ideas?
SOURCE: How to I replace the oil filter on a 2009 Toyota Camry V6 engine?
Under the engine in the front you will see an aluminum cover.There is a square hole that fits a 3/8 ratchet remove this first.The new filter comes with a drain adapter that snaps in the hole under the cover.This lets the oil in the housing drain.Then take a oil filter cup wrench or a big channel lock to twist of the larger portion.Then change the filter and o-ring and reinstall.Make sure the o-ring on the square drive cover is there also
SOURCE: How to remove radio faceplate on 2003 Toyota Camry?
U don't have to remove anything, just get a laser lens cleaning disk from any store that carries music CD's Walmart has them for about $6
SOURCE: power window toyota camry
Fuse box is by drivers left knee. Above this are the flashers and about 3 inches above this is the circuit breaker for the windows and door locks. breaker is silver, about 1/2 by 5/8 inch and in the center is the button you need to push in to reset. I used an unbent paper clip to press it. Make sure unit is not energized. May need to unplug breaker first. Press in center button until it clicks.
SOURCE: need Toyota Camry radio/cassette/cd model 86120 33100 harness
You can try any Circuit City or any car stereo place or you can wire it yourself you just have to figure out which wire is power,ground,front and rear speakers. Yeah the hornance makes it easier but it can be done without it
SOURCE: Toyota Corolla Verso 2004 CD problem
I've now fixed two of these units and they both had identical problem and solution.
The problem was an intermitant fault, that after a random time, would result in a noticable snap and a failure of the sound system both radio and cd player.
Solution:- In both cases this is diy fixable with just some screwdrivers and a soldering iron.
First remove unit; this is done by unsnapping the two trims that house the face air vents this then exposes the fixing screws 2 at the rear 2 at the front, remove screws then theclimate control facia ,this allows the unit to come out far enough to unplug all connections both to the hazards ect and the radio unit.
Once out, remove the radio lid and the facia housing the controls, this just snaps out of retainers that you systematically release with a screwdriver. remove side supports marked L & R then this exposes a number of screws to remove including a small side panel that allows you to unplug the cd interface. Note ; it is not necassary to remove the cd player from facia plate. remove two screws exposed by removing control panel then remove ribbon from socket that supports lcd screen. This should then allow you to gently ease the radio unit clear of the facia plate and cd. Once clear remove all screws retaining back plate and pcb and lift pcb clear of case. Now viwed from the top and front you will see a heat sink that supports 4 big transisters , re-solder all legs of these transisters (3 legs each) this has cured the problem twice for me now. Assembly is reverse of reassembly plug in and check out those sounds,
2,722 views
Usually answered in minutes!
×