1988 Honda Prelude Logo

Related Topics:

A
Anonymous Posted on Aug 26, 2012

Replace fog light bulb on 1988 honda prelude - 1988 Honda Prelude

5 Related Answers

Anonymous

  • 2 Answers
  • Posted on Jul 29, 2008

SOURCE: 89 honda prelude power steering belt

there is an adjustment bolt on the back side of the idler pulley . you just loosen up the nut on the front of the pulley , then turn the 12 mm bolt under the pump on the back side of the pulley.

Ad

Anonymous

  • 214 Answers
  • Posted on Mar 12, 2009

SOURCE: oil light reset procedure for 92 honda prelude

theres a lil slot on the lower left face plate of the dash.. Insert Ignition key or suitable tool (very small screwdriver) and hold for a few seconds.. this will reset the mileage counter and turn off the oil lamp.. Thankx

Anonymous

  • 116 Answers
  • Posted on Mar 15, 2009

SOURCE: Honda Prelude Sunroof

go to a Honda Dealership and ask them to order a new sunroof gasket replacement kit. they have em and they may even have instructions on how to remove the old and install the new. I've had awesome experiences with the Honda parts division. Hope this was the answer you wanted. (don't even look for an after market one..unless you want a nightmare)

c17hydro

Greg Bernett

  • 2993 Answers
  • Posted on Jul 15, 2009

SOURCE: how to change fog lights bulbs on my 2005 honda

548ae69.gif

  1. Remove the fog light mounting screw.
  2. Disconnect the connector from the fog light.
  3. Turn the socket about 45° counterclockwise and remove it from the housing.
  4. Remove the bulb from the socket.
To Install:
  1. Install the bulb in the socket without touching the glass with bare hands.
  2. Turn the socket about 45° clockwise to install it.
  3. Connect the connector to the fog light.
  4. Install the fog light mounting screw.

Anonymous

  • 32 Answers
  • Posted on Oct 03, 2009

SOURCE: fuel pump location

there are two locations one is inside the fuel tank and the other is beside the fuel tank before the fuel filter

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Replacing the heater core

Hey Eric,here's a guide on how to replace.
0helpful
1answer
0helpful
1answer

Blinkers not working fuses ok

mcdevito75 here, If the fuses are ok, Check the bulbs themselves, also the Flasher unit sometimes located in the fuse box is faulty, also chek the wireing to the back lights for a good ground.
0helpful
1answer

Replace fog light bulb for 2006 Honda Odyssey

Touring Model
Use a wrench to remove the mounting bolt from the underbody through the hole in the splash shield.
Remove the fog light assembly from the bumper by pulling its inner edge first, then the whole assembly out of the bumper.
Remove the electrical connector from the bulb by pushing on the tab and pulling the connector down.
Remove the bulb from the fog light assembly by turning it one quarter turn counterclockwise.
Push the electrical connector onto the new bulb.
Turn on the fog lights to test the new bulb.
Reinstall the fog light assembly into the bumper. Tighten the mounting bolt.
Insert the new bulb into the assembly and turn it one-quarter turn clockwise to lock it in place.
Hope this helps you.
1helpful
1answer

My 1988 honda prelude 2.0 si left headlight broken cant figure out how to take it off and replace it, the motor still works I hear it try to lift the headlight up but isn't it connected the arm is snapped...

its easy i did mine you have to buy the whole light not just the bulb. All you gotta do it unscrew the black plastic around it and then pop the light out. make sure to check it works before srewing it back in
9helpful
1answer

How to change fog lights bulbs on my 2005 honda

548ae69.gif
  1. Remove the fog light mounting screw.
  2. Disconnect the connector from the fog light.
  3. Turn the socket about 45° counterclockwise and remove it from the housing.
  4. Remove the bulb from the socket.
To Install:
  1. Install the bulb in the socket without touching the glass with bare hands.
  2. Turn the socket about 45° clockwise to install it.
  3. Connect the connector to the fog light.
  4. Install the fog light mounting screw.
0helpful
1answer

1988 honda prelude windows and sunroof won't work

There is a relay, and it should be in the fuse box. If it's not there, you may have a Constant Control Relay Module (CCRM). It's a big black and silver box around the radiator. The relay could be housed here. If so, you'll have to replace the entire box as these relays are not serviceable.
1helpful
1answer

Cambelt

You can download the entire manual from www.pdftown.com
Here is the link to the shop manual for the 88 prelude that I used to do my Cam Belt.
http://pdftown.com/Honda-Prelude-1988-Service-Manual.html
Hope this helps...
0helpful
2answers

Clutch goes to floor without engaging

how do you bleed a hydrolic clutch on a 1988 Honda Prelude
Not finding what you are looking for?

102 views

Ask a Question

Usually answered in minutes!

Top Honda Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...