SOURCE: 2001 Toyota Echo Fuel consumption
EPA mileage figures are estimates, and seldom does it have anything to do with the real world, My new car is rated at 19 city and 28 hiway, it gets 22 MPG max. The only thing you can do is make sure the pressure in the tires is correct and run the recommened oil, keep the car in good running order.
SOURCE: set clock on echo 2001
Hi banksiah,
Turn the radio off.
Press 4 and while holding it press seek up. The clock will reset to 1:00.
To adjust the hour press and hold AM and then 1.
To adjust the minute press and hold AM and then 2.
Turn the radio on when finished.
I hope this helps
SOURCE: we broke the lugs on our toyota echo how do we
Lugs?. I guess are the wheel studs(Im in australia)
First see if toyota sells the lugs separately, if yes you can use a punch to remove the last broken bit, the new ones are installed by packing with washers and using the wheel nut to pull them back into place.
If you cant buy lugs separately, you will need a new hub from the dismantlers
SOURCE: I HAVE 2001 TOYOTA COROLLA , THE RUNNING LIGHT
First remove all the bulbs involve in the problem, then start installing the one by one, notice when the problem comeback, start looking for a melt, damage or very important wrong bulb touching two filaments at the same time.
Find the turn signal flasher and remove it, problem goes away ? inspect the circuit, the combination switch, the bulbs ans socket pig tails for short.
If you need further help, I’m available over the phone at https://www.6ya.com/expert/flavio_517b938f50183b92
SOURCE: How do you fix an Igniter Circuit Malfunction -
The problem 95% of the time is an ignition coil, if you do not have special equipment, your only tool is common sense, disconnect plugs from spark plugs, remove spark plugs,now insert the plugs in the wires and set them together touching metal ground them,
Ask somebody to crank vehicle one of those wires or 2 of them if the coil is bad wont fire or the spark will be weak and orange, blue is ok. Follow the no spark or weak spark to the coil, now swap coils , repeat the same procedure if the problem follow the coil to the wires that were ok before the problem is the coil if the problem is still in the same position the problem is harness wires or computer.
If you need further help, I’m available over the phone at https://www.6ya.com/expert/flavio_517b938f50183b92
85 views
Usually answered in minutes!
×