What does code p1000 mean on my car

SOURCE: Engine light on Diagnostic code is P0601

it is an internal problem in the pcm....if the car is under 8years old and 80000 miles take it to the dealer for free replacement under a fed emissions standard....if over you will have to pay...it could eventually leave you stranded

SOURCE: CAN YOU TELL ME WHAT THE P1000 CODE MEANS FOR A

P1000 means a drive cycle has not completed, it will only clear itself after driving the vehicle through certain driving conditions. If you try to clear the code, it will reappear until you repeat the drive cycle. I am not too familiar with what AE will show, but if you can access Mode 6 data or the OBD Drive Cycle(These are two options from the IDS at Ford), It may help to show what tests have either failed or not completed. Heres what must be done to clear the P1000:


Note: The IAT PID must be between 10-38°C (50-100° F) during the OBD II drive cycle to enter into all the OBD II monitors. The FLI PID must be between 15% and 85% at all times.

Drive in stop-and-go traffic with at lease 4 idle periods (30 seconds each) while observing the status of the OBD II monitor on the scan tool. If the exhaust gas recirculation (EGR), heated oxygen sensor (HO2S), evaporative emission (EVAP), secondary air (AIR) (if applicable) or catalyst efficiency monitor have not completed, drive on the highway at a constant speed over 64 km/hr (40 mph) not to exceed 104 km/hr (65 mph) for up to 15 minutes. Heavy accelerations, sudden decelerations and wide open throttles are not recommended. If the scan tool sends out a three pulse beep at any time, the OBD II drive cycle has completed.

If there is only one certain component that hasn't completed its test, there are individual driving conditions to help those tests pass or fail if something is wrong.

SOURCE: need to know what a p1000 diagnostic code means for a jaguar s ty

Looks like you have acommunication problem with the computer, it is going in to safe mode. Check all computer connections before you go to jaguar.
I have attached a picture of the error code.
hope this helps

Romel Edmondson

• 68 Answers
• Posted on Jan 19, 2009

SOURCE: Auto Diagnostic Trouble Code

cORRECT. tHIS CODE DOES DEALs With emmissions. P1400 deals with the EGR valve. In case u are not aware, EGR stands for Exhaust Gas Re-circulation. What really this valve does is that it re-cycles some of the exhaust gases into the cylinder for combustion. The EGR valve might be blocked or has malfunctioned. It is advised that this valve changed or consult with a mechanic who is knowledgeable about this technology. a malfunctioned/dis-abled EGR system will cause the car to fail an emissions test, and may cause the EGR passages in the cylinder head and intake manifold to become blocked with carbon deposits, necessitating extensive engine disassembly for cleaning. So it is advised that u repair this ASAP

SOURCE: Jeep Grand Cherokee Limited P0700 diagnostic problem

P0700 means there is a transmission fault code in the transmission controller. Since the transmission controller doesn't have a light attached, it tells the engine controller to turn the light on using this code. You'll have to access the transmission controller to further diagnose the problem.