How do you check the transmission fluid
•
•
•
Instructions Locate the dipstick for your transmission. It is usually near the back
of the engine, and the stick handle is either a T-handle or a ring handle. Top Degree & Financial Freedom! Free Tuition & Income
Opportunities Grasp the dipstick handle and pull straight up until the end of the
stick clears the housing tube. Wipe the stick off with a rag, and push it all
the back down into the tube. Pull the stick all the way out again and hold it so you can see the end
of the stick and the film of fluid that clings to it. Look for the level indicators stamped or drilled into the dipstick. You
should see two sets of indicators. One set is for checking the fluid when the
engine is cold, and the other set is for checking the fluid when the engine is
hot. Each set of indicators is marked with a "full" line and an
"add" line. Determine whether your transmission fluid is at the proper level by
finding the spot on the dipstick where the film of fluid ends. If the film ends
near the "full" mark or somewhere near the halfway point between
"full" and "add," your transmission has an adequate fluid
level. Return the dipstick to the holding tube and push it all the way back
down into the tube. Fully seat the dipstick in the holding tube
187 views
Usually answered in minutes!
×