I need a diagram of how the belt goes on
5.9L DIESEL
The 5.9L diesel engine accessory drive system (with a/c) consists of :
CAUTION:
When installing the accessory drive belt, the belt must be routed correctly. If not, engine may overheat due to water pump rotating in wrong direction. Refer to or for correct engine belt routing. The correct belt with correct length must be used.
1.
Position drive belt over all pulleys except water pump pulley.
2.
Attach a 1/2 inch ratchet to tensioner.
3.
Rotate ratchet and belt tensioner clockwise. Place belt over water pump pulley. Let tensioner rotate back into place. Remove ratchet. Be sure belt is properly seated on all pulleys.
Diagram can be found at the link below
http://serpentinebeltdiagrams.com/2006-2008-dodge-2500-diesel/
Charlie
SOURCE: Need serpentine belt diagram for Dodge Ram 3500 diesel truck
no you should be able to do it There should be a routing label on the underside of hood or on the radiator support/ Its should not be very hard if you have one already just loosen the Alternator it will slide down get the other one ready look to see the way its routed then slide the new one and tighten up the alternator thats it/ Please rate my response thank you very much
SOURCE: serpentine belt diagram 2007 dodge 5.9 3500
get the belt routing from the local dealer.
they will not charge alot of money for a reprint from the factory service manual.
also
dayco belts come with the belt routing on the box.
7,171 views
Usually answered in minutes!
How much to repair a water pump, serpentine belt and the pulley on a 2004 dodge ram 3500
I need to know where the spring goes and how the light clips back in on my 2000 dodge 3500
replace serpentine belt
×