My hyundai accent cranks wont start though 2 hours later it started i drove it home about 35 minutes and this morning it wont start
A mechanic would use a fuel pressure gauge, you could spray starting fluid or carb cleaner into the throttle body to see if it will start on that.
Also check for spark at the plugs.
SOURCE: 2002 Hyundai Accent Problem
first thing i need to know is did the timing belt break?
second is are you sure you aligned the timing marks and after the belt tensioner was tight you rechecked to make sure the timing stayed where you had it.
next step would be a compression check to if a valve was bent whenchanging the belt
i have seen this happen and this engine is an interferance engine.
later paul
SOURCE: 99 hyundai accent starts sometimes. not battery
ok when the check engine light comes on that usually indicates a engine malfunction...what you can do is go to your local autozone and they can do an OBDII test for free..my bet says it is the cam or crank sensor.. DO NOT SHUT THE CAR OFF AT AUTOZONE..LOL
SOURCE: Hyundai Accent losing power when hot
the engine losing power, check your coolant level, if it is extremely low the temp gauge will not show the engine is actually hot. The tranny sounds like you have a filter that is clogged, tranny fluid thins when it gets warm and will past thru a filter that is clogged, but in the morning the fluid is thicker and will not flow thru the filter without manually shifting it
SOURCE: 2002 1.3 accent. Only done this once before in 9
hi there i have had loads of problems with these accents fault is with your crank sensor.
Testimonial: "100% correct! Thanks"
SOURCE: I have hyundai accent 2003. While driving the
#1. Scan for trouble codes. If any, record them and let us know which ones they are.
#2. Connect a fuel gauge to the fuel delivery line at the engine... try to start the engine while monitoring fuel pressure... if there is fuel pressure (approx 35 to 50 lbs), the problem is elsewhere.
If no fuel pressure, check fuel pump relay, fuse, wiring to fuel pump connector (power & ground - use 12volt test light). If power & ground are present, problem is the pump (fuel filter is attached to the fuel pump inside the tank).
#3. Check injectors for injector pulse, check ignition coils for spark to spark plugs.
1,155 views
Usually answered in minutes!
×